Hacker HC 1392 A PS Assembly Manual - page 11
9mm
9mm
Na trup nasaďte motorový kryt (6), na motor připevněte vrtuli a vrtulový kužel
(27). Podle otvorů v mot. krytu (6) vyvrtejte vrtákem 1,5mm otvory do trupu.
Put the motor cover (6) on the fuselage, install propeller and spinner. Drill holes to
to the fuselage by motor cover, use drill diameter 1,5mm.
o 1,5mm
o 2,5mm
-
-
27
27
12
28
20
1
3
2
8
9
6
6
www.hacker-model.eu
11
Při kompletaci modelu ve verzi RTF postupujte dle bodů označených *.
For completation RTF version of model follow steps marked with *.
V motorovém krytu (6) zvětšete otvory na průměr 2,5mm, vrtejte ručně. Nevrtejte
do trupu!
Resize the holes in the motor cover (6) to diameter 2,5mm. Don´t use drill-machine,
just your fingers. Don´t drill the fuselage.
27
6
Motorový kryt (6) připevněte na trup čtyřmi šrouby (20). Utahujte opatrně!
Attach the motor cover (6) to the fuselage with 4 screws (20). Tighten the screw
carefully.
Na trup (1) nasaďte křídla (2, 3). Nosníky křídel zčásti zasuňte do otvorů v trupu,
propojte servokabely a křídla doražte až k trupu.
Attach the wing (2, 3) to the fuselage (1). Insert wing spars into holes in the fuselage
partially, connect servocables and push wing panels (2, 3) to the fuselage fully.
Poloviny křídla k trupu upevníte dotažením šroubu. Použijte dlouhý inbus klíč SW4.
Šroub utahujte s citem jen tak, aby křídlo nebylo možné snadno vysunout!
Fix the wing (2, 3) to the fuselage (1) tightening the screw. Use long inbus SW4.
Tighten the screw carefully, only to fix the wing, not to destroy the wooden parts!
K utažení šroubu použijte dlouhý inbus klíč SW4. Šroub utahujte s citem jen tak, aby
křídlo nebylo možné vysunout, ne aby došlo k poškození dřevěných částí trupu!
Use long inbus SW4. Tighten the screw carefully, only to fix the wing, not to destroy
the wooden parts!
Na plastový kryt (8) nalepte samolepky “okna” (9).
Apply the stickers “windows” (9) to the plastic former (8).
Do trupu (1) vložte a zalepte aretační tyčku (12). Lepte tavnou pistolí v rozích trupu.
Insert stick (12) into the fuselage (1) and glue the stick (12) with hot glue in corners.
zatlačit
push
zatlačit
push
utáhnout
tighten
přijímač /
receiver
přijímač /
receiver
24mm
24mm
42
44
46
48
41
43
45
47