Hacker HC 1392 A PS Assembly Manual - page 9
zatlačit
push
otočit
turn
zacvaknout
clik
13
14
15
11
11
7
10
1
1
10
7
7
Připravte si pohonnou jednotku (motor, regulátor). Motor připravte na tzv.
„zadní montáž“. Pokud si konektory na motor a regulátor letujte sami pracujte
pečlivě a kvalitně. Při letování konektoru baterie k regulátoru dbejte na správnou
polaritu.
Prepare the power set (motor, speed controller). Motor will be mounted in front
of the firewall. If do you solder the connectors on the motor and speed controller
by your own make it carefully and well. Solder the battery connector to the speed
controller with the correct polarity.
19
www.hacker-model.eu
9
Při kompletaci modelu ve verzi RTF postupujte dle bodů označených *.
For completation RTF version of model follow steps marked with *.
MC-65A
MC-65A
MFORCE 3548CA-5
MFORCE 3548CA-5
13/8” (3S LiPo)
13/8” (3S LiPo)
Sestavte hlavní podvozek z dílů (7, 10, 13, 14, 15) dle schématu.
Assemble landing gear parts (7, 10, 13, 14, 15) according to the scheme.
Podvozek přišroubujte do trupu šrouby (17) s podložkami (18).
Screw the landing gear in the fuselage (1) with screws (17) and washers (18).
17, 18
Ostruhu (11) natočte dle obrázku a zasuňte ji do otvoru v trupu (1).
Turn the tailwheel (11) by picture and insert it into the hole in the fuselage (1).
Po zasunutí ostruhu (11) pootočte o 90 stupňů.
After instertion turn the tailwheel (11) 90 degrees to the final position.
4
4
4
1
1
1
Ocelovou strunu ze směrovky nasaďte do drážky v ostruze (11) a zamáčkněte.
Insert the string into the slot in the plastic part of the tailwheel (11). Push the string
to the slot.
Ocelová struna zacvaknuta v drážce.
String is inside the slot.
Ložisko ostruhy přilepte tavnou pistolí nebo CA lepidlem k trupu (1).
Glue the plastic part of the tailwheel (11) to the fuselage (1) with the hot glue or
with the CA glue.
1
1
25
26
27
28
29
30
31
32