Hafco BS-460AS Instruction Manual - page 7
3.3
The saw bow
Machine parts consisting of drive members (gear
motor, variable speed motor, and flywheels),
tightening and guide (bladetightening slide, blade
guide blocks) of tool.
3.4
The vise system
A hydraulic vise is used for clamping work
material. Each of the vises has a miter slot, which
is good for the right or left side’s angle cutting to
60°.
3.5
The base
The base is the structure supporting the saw bow
(the bow pivot point and respective blocking
system), the vises, and containing chip tray and
coolant system.
3.6
Chip tray
3.7
Blade broken micro switch
This machine is equipped with automatic power
shut-off safety device to prevent any further
damage when a blade has been broken. There is
a reduction in tension when an adjustment bolt
actuates micro switch’s plunger. To keep the
micro switch in proper contact with the blade’s
tension. An adjustment of the actuator bolt is
required.
3.8
Chip brush
This model has a powered chip brush driven by
an axle transfer from the drive motor. The chip
brush is designed to clean the blade thus
prolonging the life of the blade.
3.9
Blade speed indicator
A digital display indicates the blade speed in MPM.
This works in conjunction with speed changing
dial to give you precise control of blade speed.
Removable chip tray for capture of chips and
debris.
7
Instruction Manual for BS-460AS (B035)
31/03/2016