Hafler IRIS Owner's Manual - Power Connections
The IRIS Tuner is shipped with styled end caps on its front
panel. Rack-mounting ears are available from the factory
for standard 19”-wide racks.
POWER CONNECTIONS
The IRIS Tuner is internally connectable for virtually all AC
line power systems. Unless otherwise labelled, all units are
wired for
120
volts AC,
5O/60
Hz. Consult the factory for
information on alternate connections.
In most audio systems, it will be most convenient to plug
the tuner into the preamplifier’s switched outlet.
AUDIO CONNECTIONS
A standard RCA phono-type patch cord has been provided
for the audio signal connection. Simply connect this cord
from the rear-panel output jacks to the “tuner” or “radio”
input of the preamplifier.
ANTENNA CONNECTIONS
A simple “T” shaped dipole ribbon antenna has been sup-
plied with your IRIS Tuner. Connect its leads to the rear
panel terminal strip marked “300 ohm”.
For best results, the “arms” of the antenna should be fully
extended, and mounted against a wall or equipment
cabinet. For further information about placement of this
antenna, as well as guidance concerning alternate antenna
types, see the section “Additional Information”.
REMOTE CONTROL CONNECTIONS
The following applies only to those audio systems using an
IRIS Preamp with the remote option installed.
The IRIS Tuner has two recessed male connectors on the
back panel.
They are internally connected together to
allow the IRIS digital data-bus to “daisy-chain” to other
IRIS-compatible accessories.
Connect either end of the supplied ribbon-type umbilical
cable to either of the tuner’s connectors. Note that both of
the cable’s connectors are keyed, and therefore fit only one
2