Hafler IRIS Owner's Manual - (8) Stop Key
higher tuning resolution is included in your tuner for both
European use and to allow for slight intentional off-tuning,
which is sometimes useful in unusual reception situations.
(9) SCAN KEY (AUTOMATIC TUNING)
This mode will usually be preferred for locating stations.
Pressing SCAN initiates an automatic band-scanning mode
which pauses for four seconds on stations, then resumes
the SCAN.
(8) STOP KEY
This key terminates the SCANNING mode. To select a
desired station during the SCAN mode, press STOP during
the four second pause on that station.
Remember--as some other tuners operate differently--you
must always press STOP once SCAN has located a station
you wish to listen to.
You should also use STOP to terminate SCANNING before
attempting to use the STORE mode--as STORE alone does
not terminate the automatic SCANNING mode.
ADDITIONAL DETAILS ABOUT THE
SCAN MODE
SCANNING is always up in frequency, unless DOWN is
pressed before or during the
SCAN.
A DOWN-SCAN may be reverted to UP-SCAN by briefly
pressing UP, during the SCAN mode.
After reaching either end of the FM band, the SCAN will
resume at the opposite end of the band and begin to
re-scan it again.
During the four-second SCAN pauses, pressing SCAN
again results in immediate resumption of scanning, in the
existing SCAN direction.
Also, during these pauses, briefly pressing the UP or
DOWN keys will also result in SCANNING resumption, in
the direction keyed. However, holding either of these keys
for one second will drop the tuning mode back to manual
UP/DOWN format.
4