Haier 10518358 Use And Care Manual - Air Conditioner Use

8

9

1.   Remove the clear plastic film from the control panel.

2.    Press POWER to turn on the air conditioner. The Power  

indicator light will turn on.

 NOTE: When the air conditioner is plugged in, the LED display 

will show “88” for 3 seconds. After the air conditioner is turned 

on for the first time, the display will show the current room 

temperature and the fan is set to Low speed. When the air 

conditioner is turned on at all other times, the display will show 

the previous settings for 5 seconds, and then show the current 

room temperature.

3. Select mode. See “Mode.”

4. Select fan speed. See “Fan Speed.”

5. Set temperature. See “Temperature.”

1.    Press MODE until you see the indicator light glow for the 

desired setting.

2.  Choose Fan, Cool, Energy Saver or Dehum.

■

    Fan—Only the fan runs. Press SPEED to select High, Med 

or Low fan speed. The display shows the current room 

temperature.

■

    Cool—Cools the room. Press SPEED to select High, Med or 

Low fan speed. Press the TEMP/TIME up or down  

arrow button to adjust the temperature.

■

    Energy Saver—Fan runs only when cooling is needed. Press 

SPEED to select High, Med or Low fan speed.  

Because the fan does not circulate the room air continuously, 

less energy is used, but the room air is not circulated as often.

■

    Dehum—Dries the room. The air conditioner automatically 

selects the temperature. Fan runs on Low speed only.

 NOTE: Dehum mode should not be used to cool the room.

NOTE: After 5 seconds, display will show the current room 

temperature.

NOTE: In Dehum mode, the Speed button will not operate.

1.    Press FAN SPEED until you see the indicator light glow for 

the desired setting.

2.    Choose High, Med or Low.

■

  High—for maximum cooling

■

  Med—for normal cooling

■

  Low—for minimum cooling

NOTE: After 5 seconds, the display will show the current room

temperature.

Operating your air conditioner properly helps you to obtain the

best possible results.

This section explains proper air conditioner operation.

IMPORTANT:

■

   If you turn off the air conditioner, wait at least 3 minutes before 

turning it back on. This keeps the air conditioner from blowing a 

fuse or tripping a circuit breaker.

■

    Do not try to operate your air conditioner in the Cool mode when 

outside temperature is below 61°F (16°C). The inside evaporator 

coil will freeze up, and the air conditioner will not operate prop-

erly.

NOTE: In the event of a power failure, your air conditioner will 

operate at the previous settings when the power is restored.

AIR CONDITIONER USE

Starting Your Air Conditioner

Mode

Fan Speed