Haier 2HUM14HC03 Operation Manual - page 2
2
Outdoor Unit
Loading of the battery
1
2
3
4
Parts and Functions
Indoor Unit
OUTLET
INLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
Remote controller
Remove the battery cover;
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
Be sure that the loading
is in line with th
e" + "/"-";
Load the battery,then put on the cover again.
Clock set
Press CLOCK button, "AM" or "PM" flashes.
Press or to set correct time. Each press
change quickly. After time setting is confirmed,press SET,
"AM "and "PM" stop flashing,while clock starts working.
or decrease 1min. If the button is kept pressed,time will
will increase
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
When electronic-sta rted type fluorescent lamp or change- over
wireless telephone is installed in the
ver is apt to be disturbed in receiving the signals,
so the distance to the indoor unit should be shorter.
type fluorescent lamp or
room, the recei
Note:
Full display or unclear display during operation indicates the
ries have been used up.Please change batteries.
If the remote controller can't run normally during operation, please
reload several minutes later.
batte
remove the batteries and
Please be subject to the actual produce purchased the
above picture is just from your reference
Please be subject to the actual produce purchased the
above picture is just from your reference
Air Purifying Filter
(inside)
Inlet
1
Inlet grille
2
Outlet
3
(adjust left and
Vertical blade
right air flow)
4
Display board
Horizontal flap
(adjust up and down air flow.
Don't adjust it manually)
Emergency Switch
6
7
8
5
1
2
3
4
5
6
7
8
1. Mode display
2. SWING display
3. FAN SPEED display
4. SLEEP display
5. LOCK display
6. SIGNAL SENDING
7. TIMER OFF display
8. TIMER ON display
LO
MED
HI
AUTO
1
2
3
5
6
7
8
9
10
4
ON/OFF
FAN
MODE
SWING
TIMER
CLOCK
SET
SLEEP
LOCK
RESET
11
12
14
15
16
17
13
18
19
20
21
22
POWER/SOFT
LIGHT
23
POWER
SOFT
BLANK
9. CLOCK display
10.TEMP display
11. POWER ON/OFF button
12. MODE button
13. FAN button
14. HOUR button
15. SWING button
16. SLEEP button
17. LOCK button
Used to lock buttons and LCD
display.
18. TEMP.SETTIN button
19. SET / LIGHT button
20. TIMER button
21. CLOCK button
Used to set correct time.
22. RESET button
When the remote controller
appears abnormal, use a sharp
pointed article to press this
button to reset the remote
controller normal.
23. HOUR / POWER/SOFT button
Used to set clock and timer setting.
Every time the button is pressed,
display changes as follows:
Operation mode
AUTO
FAN
COOL
DRY
Remote controller
HEAT
LOCK
RESET
TIMER
CLOCK
SET
SLEEP
POWER/SOFT
LIGHT
4
Hint:
Remove the batteries in case won't be in use for a long period. If
there is any display after taking-out, just press reset key.