Haier AB142ACBBA Operation Manual - page 15
13
Guide to Operation
Timer On-Off
At this time the will flash.
ON
OFF
ON
OFF
12:00
12:00
12:00
12:00
A
M
P
M
A
M
P
M
TIMER ON TIMER OFF TIMER ON-OFF
BLANK
Operation mode will be displayed on LCD.
(except for Timer, Sleep, Swing)
(2)TIMER mode selection
Press TIMER button to change TIMER mode.
Every time the button is pressed, display changes
as follows:
Select your desired TIMER mode (ON or OFF)
(1)After unit start, select your desired
operation mode.
ON
(3)Timer setting
Press TIME button.
Every time the button is pressed, time increases
10min.If button is kept depressed, time will change
quickly.
Every time the button is pressed, time decreases
10min.If button is kept depressed, time will change
quickly. Time will be shown on LCD. It can be
adjusted within 24hours. AM refers to morning and
PM refers to afternoon.
(5)Time setting for TIMER OFF
Time displayed: Unit starts at X hour X min.
After time setting, press TIMER button to confirm.
"ON" stops blinking, While "OFF" starts blinking.
(4) Time confirming for TIMER ON
Follow the same procedures in "Time setting
for TIMER ON".
(6)Time confirming for TIMER OFF
After time setting, press SET button to confirm
"OFF" stops flashing.
Time displayed: Unit stops at X hour X min.
To cancel TIMER mode
According to the Time setting sequence of TIMER ON or TIMER OFF, either Start-Stop or
Stop-Start can be achieved.
MODE
FAN
SWING
TEMP
CLOCK
SET
TIMER
SLEEP
RESET
FILTER
RESET
ON/OFF
1
2
PM
3
4
6
5
ROOM
Just press TIMER button several times until TIMER mode disappears.
A
M
OFF
ON