Haier AB142ACNBC Operation Manual - Remote Controller Functions
7
Clock Set
Display when healthy run function is set.
14.TIMER OFF Display
15.HUMIDIFICATION Display
16.TEMPERATURE Display
17.LOCK State Display
18.BATTERY Energy Display
Display when in low battery to remind
customer to change the battery.
19.STRONG/QUITE Run Display
20.SIGNAL SENDING Display
21.NEW AIR Display
22.ELECTRICAL HEATING Display
23.HEALTH Display
24.SLEEP State Display
25.Operation MODE Display
AUTO RUN
COOL RUN
DRY RUN
FAN RUN
26.COMFORTABLE RUN Display
27.FAN SPEED Display
28.AUTO SWING Display
29.TIMER Display
30.FILTER Display
31.TIMER ON Display
Remote Controllerí Operation
The distance between the signal transm-
ission head and the receiver hole should
be within 7m without any obstacle as well.
When unit is started for the first time and after replacing batteries in remote
controller, clock should be adjusted as follows:
1.Press CLOCK button,clock indication of ì AM ì or ìPMî flashes.
2.Press or to set correct time,each press will increase or decrease
1 min. If the button is kept pressed, time will increase or decrease quickly.
3.After time setting is confirmed,press ìSETî , AM or PM stop flashing,
while clock starts working.
Note:AM means morning and PM means afternoon.
Donít throw the controller,prevent it from
being damaged.
When in use, put the signal transmission
head directly to the receiver hole on the
indoor unit
When electronic-strated type fluorescent lamp or
change-over type fluorescent lamp or wireless
telephone is installed in the room, the receiver is
apt to be disturbed in receiving the signals so the
distance to the indoor unit should be shorter.
Loading of the battery (load the batteries
as illustrated)
Remove the battery cover
Load the battery
Put on the cover again
Installing the cover is opposite to removing it
Confirmation indicator
If no indication after press ON/OFF button,reload
the batteries.
Note:
AUTO
LO
MID
HI
AUTO
Use two new same-typed batteries when loading.
If the remote controller canít run normally during
operation ,please remove the batteries and reload
them few minutes later that will be ok
If the display of remote controller is faded(someti-
mes run abnormally),which indicates no battery,so
please change the batteries
Hint:
Remove the batteries in case unit will not be in
usage for a long period.if there is any display after
taking-out just need to press reset button with a
sharp article.
When throw away the waste batteries, please
perform in accordance with the local regulation.
When throw away the waste batteries, please
perform in accordance with the local regulation.
First slightly press the position marked with
and push down the cover,then as shown in the
figure:holding the upper part of the remote con-
troller with the left hand and the right hand
slightly grasps the battery box cover and forces
on the arrow direction to remove the cover.
SLEEP
SET
TIMER
LOCK
RESET
MODE
CLOCK
1
Be sure that the loading is in line with the ì + î ì - î
pole request as illustrated on the botton of the box.
Remote Controller Functions
2
3