- DL manuals
- Haier
- Air Conditioner
- AD092XLERA
- Operation And Installation Manual
Haier AD092XLERA Operation And Installation Manual
Summary of AD092XLERA
Page 1
Low e.S.P. Duct type indoor units operation & installation manual ad092xlera ad122xlera ad142xlera ad182xlera r410a multi split series room air conditioner no.0010577705 please read this manual carefully before using this air conditioner. Please keep this manual safely for future use..
Page 2: Contents
Contents cautions .................................................................................... Safety precautions..................................................................... Notes for safety.......................................................................... Parts and function...
Page 3: Cautions
Cautions 1 disposal of the old air conditioner before disposing an old air conditioner that goes out of use, please make sure it's inoperative and safe. Unplug the air conditioner in order to avoid the risk of child entrapment. It must be noticed that air conditioner system contains refrigerants, wh...
Page 4: Cautions
All the cables shall have got the local authentication certificate. 6. The breaker of the air conditioner should be all-pole switch; and the distance between its two contacts should be no less than 3mm. Such means for disconnection must be incorporation in the fixed wiring. 7. The waste battery shal...
Page 5: Warning!
3 warning! Carefully read the following information in order to operate the air conditioner correctly. Below are listed three kinds of safety cautions and suggestions. Be sure to conform with the following important safety cautions. The safety cautions should be at hand so that they can be checked a...
Page 6: Cautions!
4 cautions! Conditioner should not be used for any other purpose other than airconditioning. Don't use air-conditioner for any other special purposes, e.G. The preservation and protection of food, animals, plants, pecision apparatus as well as work of art, otherwise the qualities of these stuffs may...
Page 7: Caution !
5 caution ! Please ask the dealer or specialist to install, never try by the users themselves. After the installation please be sure of the following conditions. Safety precautions incorrect installation may cause water leaking, shock and fire hazard. Please call dealer to install the air-conditione...
Page 8: Notes For Safety
Notes for safety 6 the instructions with this warning mark must be carried out strictly, for they are all concerned with safety of the product or human beings. Clean the dust filter periodically: blockage of the dust filter would reduce the cooling and heating effect, consume more power, water would...
Page 9: Parts and Functions
Parts and functions 7 indoor unit electrical box air inlet drain pan air outlet.
Page 10: Trouble Shooting
8 the followings are not malfuncition hua hua trouble shooting water flowing sound is heard when the air conditoner is started, when the compressor starts or stops during operation or when the air conditioner is stopped,it som- etimes sounds ì bi- bi-î or ìgodo-godoî. It is the flowing sound of the ...
Page 11: Trouble Shooting
9 **? On off air does not blow or the fan speed cannot be changed during drying. In dry mode, when room temperature becomes 2 c higher than temperature setting, unit rill run intermittently at lo speed regardless of fan setting during heating,indoor fan is still running even unit is stopped. To get ...
Page 12: Customer Need-to-Know
10 customer need-to-know customer need-to-know please install the air conditioner according to the requirements specified in this manual to ensure the air conditioner work well. Be careful not to scratch the surface of the case during moving the air conditioner. Please keep the installation manual f...
Page 13: When Trouble Happens
11 when trouble happens insufficient cooling or heating insufficient cooling any other heat sources in the room? Sunlight direct into the room ? Too crowed in the room ? Cooled air blown out ( when heating) when the air conditioner does not operate properly after you have checked the above-mentioned...
Page 14: Instructions to Installation
12 warning instructions to installation 1. Safety precautions please read these "safety precautions" first then accurately execute the installation work. Though the precautionary points indicated herein are divided under two headings, and , those points which are related to the strong possibility of...
Page 15: Precaution
13 precaution execute proper grounding. Do not connect the earth wire to a gas pipe, water pipe, lightening rod, or a telephone ground wire. Improper placement of earth wires can result in electric shock. An electric leakage breaker must be installed, otherwise electric shock or other accidents woul...
Page 16: 5. Installation Procedure
14 self-contained accessories 3. Accessories for installation name of parts no. A b c d e f non-adhesive tape adhesive tape connecting hose gypsum powder drain hose heat insulation material 4. Choose the installation place install the indoor unit where the weight of the unit can be supported. Instal...
Page 17: Instructions to Installation
Installation dimension:(mm) unit model ad142xlera ad182xlera ad122xlera ad092xlera a 1002 538 b 483.5 483.5 c 131 131 d 1105 610 e 255 255 f 105 105 g 880 418 h 970 508 i 220 220 1.This series' indoor units are all low static pressure type(max. 20 pa external static pressure available ). 2.An access...
Page 18: Instructions to Installation
The distance between air duct outlet and air conditioner outlet is according to the length of actually installed air duct and in service behavior of the static pressure terminal: installation sketch map for long and short air duct is showed below, when connect to short air duct, using low static ter...
Page 19: 3. Air Duct Insulation
2. Installation of air return duct 3. Air duct insulation use m8 or m10 suspension screws (4, prepared in the field) (when the suspension screw height exceeds 0.9 m, m10 size is the only choice). These screws shall be installed as follows with space adapting to air conditioner overall dimensions acc...
Page 20: Requirements
Original concrete slab use hole hinge, hole plunger or hole bolt. Steel reinforcement structure use steel angle or new support steel angle directly. Hanging of the indoor unit fasten the nut on the suspension screw and then hang the suspension screw in the tslot of the suspension part of the unit. A...
Page 21: Instructions to Installation
Supplementary refrigerant the refrigerant supplementation shall be as specified in the installation instructions attached with the outdoor unit. The added refrigerant shall be r22. The adding procedure shall be aided with a measuring meter for a specified amount of supplemented refrigerant pipe cutt...
Page 22: Instructions to Installation
The connection of indoor unit pipes must use double spanners. The installing torque shall be as given in the following table. Double-spanner operation pipe expansion dimensions as follows: 20 pipe expander a piping connection flare connection gas pipe 3-way valve indoor unit outdoor unit liquid pipe...
Page 23: 3.Installation Check
21 1. Indoor unit communication addresses setting caution! Fail to do this, the unit will not work. (2). Address setting procedure when using the dip switches sw01 and sw03. A. The dip switches sw01 and sw03 are on the indoor unit pcb. B. Change the position of dip 7 of sw01 from off to on, if fail ...
Page 24: 4.Trial Operation
22 4.Trial operation the person who has completed this installation shall be requested to conduct a test operation for check: is the temperature adjuster working normally? Does the location for installation conform to requirements? Winding up with protective plastic tape.The connection pipes,drain p...
Page 25: Failure Code
23 4 wiring of indoor unit the distance between the signal wires and the power cabes should be at least 50mm. C b a q p 1(l) 2(n) 2(n) 1(l) p q a b c l n c1 c2 to other indoor unit to wired controller(a,b,c) to outdoor unit (p q) 06 failure code (check the wired remote controller) trouble shooting (...
Page 26: Failure Code
24 failure code abnormal communication between wired controller and indoor unit pcb drainage system abnormal the short-connector disconnected, or at wrong position, or the float switch broken down or the float switch disconnected,or at wrong position failure code (check the wired remote controller) ...
Page 27: Failure Code
25 failure code failure code (check the wired remote controller) trouble shooting (outdoor unit) * * 1. Please contact the installers or distributors when trouble happens to repair it. 2. Turn the power off and power on again, if the failure code recurs, please inform the franchiser. 3. Failrue code...
Page 28
Haier group qingdao haier air conditioner electric co., ltd. Address: haier garden, qianwangang road, economic development zone, qingdao, shandong 266555, p.R.China web site: http://www.Haier.Com.