Haier AD24MS1ERA Operating And Installation Instructions - Operation

11

1

2

3

1.Press "CLOCK" switch

2.Press "    " and "    " to regulate the time.

Setting of power failure compensation function

When SW1-6 on PCB of wire controller is OFF, it will be in power failure compensation. If the SW1-6 is ON, it has no

compensation function.

When the power is on after blackout, the unit will return to the former state if compensation function is set. Otherwise, it

will stop. When restarting the unit,  press "ON/OFF" switch on wired controller.

Notes

Operation

HIGH

C

ROOM TEMP.

The timing is based on the real time. Thus, the real time should be regulated in advance.

The clock regulation steps are as follows:

3.Press "setting" switch. The setting is achieved.

If not in timing, the screen displays the real time.

If in timing, the screen displays the timing time.

If you want to know the real time, go to the first step.

"CLOCK" flickers, and the time displayed is the real time.

The time increases a minute each time you press "    " switch.

The time decreases a minute each time you press "    " switch.

HEAT

FAN

OPERATION

MODE

CLOCK UP

MODE

FAN

SWING

HEALTH

CLOCK

TIMER

CHECK

FILTER

RESET

ON/OFF

SET

RECOVERY

TEMP

TIME

Present time setting