Haier AH16NAHAAA Operation & Installation Manual - Operation
12
Operation
The timing time is on the basis of the present time. Thus, the present time should be regulated
in advance.
The clock regulation steps are as follows:
3.Press setting switch. The setting is achieved
Note:
When not timing, the screen displays the present time.
If timing, the screen displays the timing time.
If you want to know the present time, go to the first step.
The time increases a minute each time you press + switch.
Timing setting
1.Press CLOCK switch
CLOCK flickers, and the displayed time is the
present time.
2.Press + and - to regulate the time.
The time decreases a minute each time you press - switch.
Setting of power failure compensation function
When the power is on after blackout, the unit will return to the former state if compensation
function is setting. Otherwise, it stops. When restarting the unit, press ON/OFF switch on
line controller.
For wired controlled type:When J07 is disconnected, it is power failure compensation state.
Short circuit has no compensation function.
HEALTH
SET
RECOVERY
CHECK