Haier AP182ACBEA Operation And Installation Manual - page 8
EMERGENCY OPERATION AND TEST OPERATION
EMERGENCY OPERATION
MODE
TEMP
FAN
POWER
EMERGENCY SWITCH
MODE
TEMP
FAN
POWER
TEST SWITCH
Room
temperature
Designated
temperature
Timer
mode
Air flow
speed
Operation
mode
More than 26
Less than 23
26
23
Designated
temperature
None
AUTO
AUTO
HEAT
COOL
o
C
None
Anion
None
None
o
C
o
C
o
C
Operation
l
Carry out this operation only when the remote
controller is defective or lost.
l
Unit start
When the emergency operation switch is
pressed, a sound you can hear, which
means the start of this operation.
l
Follow the requirements below.
l
Unit stop ( to cancel emergency operation)
Press the emergency switch and hear a sound ,the unit stops.Control panel only
display the room temperature
TEST OPERATION
l
Use this switch in the test operation when the room
temperature is less 16
o
C
, do not it in the normal
operation.
l
Unit start
Continue to press the test operation switch
for more than 5 seconds. After you hear the
" Hua " sound twice,release your finger from
the switch, the test operation startsand the
air conditioner starts with the air flow speed
setting "Hi".
l
Unit stop (to cancel test operation)
Push the test run switch or operate with remote controller to cancel the test run.
If you use the remote controller to cancel the test run, the conditioner will then run as
per the working mode displayed on the remote controller.
Each time the power supply is switched off, and then is switched on, the conditioner
will play music once automatically. It will stop playing automatically when the starting
signal is received.
Push the On/Off button and Temp +/- button, the conditioner will play the reminding
sound.The On and Temp
are rising tone. The Off and Temp
are dropping tone.
7