- DL manuals
- Haier
- Air Conditioner
- AP48DS1ERA
- Operation And Installation Manual
Haier AP48DS1ERA Operation And Installation Manual - Operation
Summary of AP48DS1ERA
Page 1
Operation manual and installation manual please read this manual carefully before installation. Keep this operation manual for future reference. Cabinet type air conditioner –¨ 1.000 0150508963 c.
Page 3
Operation manual and installation manual please read this manual carefully before installation. Keep this operation manual for future reference. English contents cautions parts and functions operation energy saving maintenance troubleshooting indoor & outdoor unit connection installation procedure 3...
Page 5: Cautions
3 cautions disposal of the old air conditioner before disposing an old air conditioner that goes out of use, please make sure it's inoperative and safe. Unplug the air conditioner in order to avoid the risk of child entrapment. It must be noticed that air conditioner system contains refrigerants, wh...
Page 6: Cautions
4 cautions the machine is adaptive in following situation applicable ambient temperature range: if the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similar qualified person. If the fuse on pc board is broken please change it with the type of t 3.15a /250v...
Page 7: Parts and Functions
5 parts and functions –¨ 1.000
Page 8: Parts and Functions
6 parts and functions electrical heating is not available. Fan only function (this model has not this function.) (this model has not this function.).
Page 9: Operation
7 operation.
Page 10: Operation
8 operation (this model has not this function.).
Page 11: Energy Saving
Keep proper room temperature too cold or too warm is no good to your health, and power consumption will be increased as well. Air filter should be periodically cleaned if air filter is clogged, it will cause poor cooling and heating efficiency, higher power consumption and even problem may occur. In...
Page 12: Maintenance
Don't spray any paint or insecticide on the unit. Don't splash water directly on indoor unit. This will cause damage or even fire accident. This could be very dangerous disconnect power supply don't touch it with wet hand don't wash with hot water or solvent to clean the unit 10 maintenance pull it ...
Page 13: Troubleshooting
11 troubleshooting followings are not problems sound of water flowings are not problems. Sound of cracking is heard. Smells are generated. During operation, white fog or steam comes out of indoor unit. In cooling operation, unit switches to fan operation. Unit will not restart after stop. No outlet ...
Page 14: Troubleshooting
Before asking services, please firstly check your unit according to following. If your unit still can't work properly after above mentioned checks, or following problems occur, please stop it immediately and contact your dealer. Fuses or circuit breakers often blow out. Water comes out in cooling/dr...
Page 15: Troubleshooting
13 troubleshooting.
Page 16
E e e e 14 indoor & outdoor unit connection e e e e ee.
Page 17: Installation Procedure
Tools necessary 1. Screw driver 2. Hacksaw 3. 70mm dia. Hole core drill 4. Spanner (dia. 22, 36mm) 5. Spanner (16, 18, 22, 36mm) 6. Pipe cutter 7. Flaring tool 8. Knife 9. Nipper 10. Gas leakage detector or soap water 11. Measuring tape 12. Reamer 13. Refrigerant oil installation accessories followi...
Page 18: Installation Procedure
16 installation procedure indoor unit installation of indoor unit place where it is easy to route drainage pipe and outdoor piping. Place away from heat source and with less direct sunlight. Place where cool and warm air could be delivered evenly to every corner of the room. Place near power supply ...
Page 19: Installation Procedure
Drain hose shall be placed in under place. There should be a slope when arrange drain hose. Avoid up and down waves in drain hose. If humidity is high, drain pipe( especially in room and indoor unit ) must be covered with insulation material. Indoor unit slope good up down bad connect the connecting...
Page 20: Installation Procedure
18 installation procedure electrical wiring note: electrical wiring must be done by qualified person. The power supply connects from the outdoor unit. The connecting cable and power cable are self-provided. Use copper wire only. Air conditioner must use an exclusive line (over 30a) when installing a...