Haier AP96NACAEA Operation Manual - Operation Points
Change of fan speed
In COOLING mode, the air sending is set at AUTO,
when the indoor temperature is near the set temperature,
the fan speed will lower automatically.In HEATING
mode, when room temperature reaches the set temperature,
the compressor will stop running, and the fan will change
to LOW FAN or stop.
In DEHUMIDIFYING mode, the fan
speed will change automatically.
3-minute protection function
If start the unit immediately only
after it is turned off, the compressor
will start after 3 minutes have
elapsed to protect the compressor.
Operation of air conditioner
When the ambient humidity is too high,
in COOLING or DEHUMIDIFYING
mode, there may be water dropped in the
air outlet.
Anti-cold air blowing out
During Heating operation, after starting the
unit, the indoor fan motor will not rotate
immediately to prevent cold air from blowing
out.
Defrosting function
During Heating operation, when frost formed on the
heat exchanger of outdoor unit, the air conditioner
will defrost automatically for several minutes. During
defrosting, both the fan of indoor and outdoor unit
do not run. After finishing defrosting, the air
conditioner will automatically resume operation.
Hint
When the air conditioner
is in Heating mode, it
a b s o r b s h e a t f r o m
outside and release to
indoors. So the outdoor
temperature may affect
the Heating effect.
Operation points
3
?
MODE
FAN
SWING
TEMP
CLOCK
TIMER
SET
SLEEP
FILTER RESET
RESET
ON/OFF
MODE
FAN
SWING
TEMP
CLOCK
TIMER
SET
SLEEP
FILTER RESET
RESET
ON/OFF
MODE
FAN
SWING
TEMP
CLOCK
TIMER
SET
SLEEP
FILTER RESET
RESET
ON/OFF
MODE
FAN
SWING
TEMP
CLOCK
TIMER
SET
SLEEP
FILTER RESET
RESET
ON/OFF