Haier DW15-PFE SS Instructions For Use Manual - Drain Hose Connection

5

Drain hose connection

Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink, making

sure to avoid bending or crimping it. If necessary, fit a syphon trap (U-bend) with a connecting piece for

the drain hose (fig.C). The free end of the hose must be at a height between 40 and 100 cm and must not

be immersed in water.

fig.C

Attention:

The connecting piece for syphon trap (U-bend) must be solidly

fastened to the wall to prevent the drain hose from moving and

allowing water to spill outside the drain.

Electrical Connection

After making sure that the voltage and frequency values for the current in the home correspond to those

on the rating plate (located on the stainless steel inner door of the appliance) and that the electrical

system is correct for the maximum voltage on the rating plate, insert the plug into an electrical socket

which is earthed properly (the earthing of the appliance is a safety requirement mandated by law).

If the electrical socket to which the appliance must be connected is not appropriate for the plug, replace

the whole cable, rather than using adaptors or the like as they could cause overheating and burns.

Caution:

The dishwasher plug must be accessible even when the appli-

ance is installed as a built-in unit so that maintenance can be

done safely.