Haier FFM0200HVCR User Manual - Assembly and Operating
English
ASSEMBLY AND OPERATING
INSTRUCTIONS
WARNING! This appliance has a 3-prong grounded plug that must be inserted
into a matching outlet. To reduce the risk of electrical shock, this grounding plug
must not be removed from the plug. Where a two-prong wall outlet is encoun-
tered, it must be replaced: contact a qualified electrician. DO NOT attempt to
remove this safety feature. Use your fan only with adequate wiring that is up to
Code. Connect to properly grounded outlets only.
UNPACK YOUR FAN AND CHECK THE
CONTENTS
• Fan Head with Tilt Adjustment Knobs
• Break-down Stand
• Wall Bracket
• Owner’s Manual
ASSEMBLY INSTRUCTIONS
1. Place the fan head and stand facedown on a flat and stable surface as shown
in the picture.
2. Remove the two screws from the steel tubes attached to either side of the
fan head, and save them for step 4.
3. Slide the left side of the stand into the steel tube attached to the left side of
the fan head and align the holes.
4. Loosen the tilt adjustment knob on the right side of the fan head slightly to
allow the attached steel tube to pivot. Carefully insert the other end of the
stand into the steel tube and align the holes.
5. Carefully insert the screws from step 2 back into the holes and tighten them.
Please be sure to re-tighten the tilt adjustment knobs to prevent the fan
1
2
3
4
5