Haier FFM0200HVCR User Manual - page 4
English
3
head from tilting.
OPERATING INSTRUCTIONS:
1. Set the fan on a dry, stable, flat surface.
2. Make sure the Speed Control is in the OFF position. Then connect the
power plug to a standard 120-volt AC outlet.
3. Pass the power cord through Cord Clip on the stand.
4. Turn the speed control to the desired setting – Off, Low, Medium or High.
5. To change the tilting angle of the fan head, loosen the Tilt Adjustment Knob
on both sides of the fan head, tilt the fan head to the desired angle and
tighten the Knobs.
Note: It is normal for the motor to feel warm to the touch during operation. The
motor is thermally protected and will automatically shut off if it overheats for any
reason. If this happens, immediately disconnect the fan from the power outlet.
The motor bearings have been permanently lubricated at the factory and do not
require any additional lubrication.
CLEANING
WARNING! Unplug the power cord from electrical supply source before
cleaning. After servicing, any safety device (including grills and blades) must be
reinstalled or remounted as previously installed.
• Use a soft damp cloth to clean, then wipe with a dry cloth. Do not use
harmful cleaners. Do not bend the blades.
• Wash the guards and blades with water and a soft brush. Avoid harsh
chemical cleaners. DO NOT IMMERSE THE MOTOR IN WATER. Allow the fan
to dry completely before use.