Haier HD80-256A User Manual - page 12
Daily use
GB
GB
Care and cleaning
22
23
Empty the water tank
During operation, steam condenses to water which is collected in the water tank. The tank
must be emptied
after each drying cycle. The flashing LED
will remind you.
If the tank will
not emptied:
▶ the lamp will flash during the programme.
▶ an acoustic signal will sound.
▶ the programme will automatically interrupted; the laundry remains wet.
▶ the „Start/Pause“ button must be pressed after the tank was emptied in order to con-
tinue the programme.
WARNING!
Do not use the water for any kind of drinking or food processing.
CAUTION!
Following maintenance activities must be carried out
after each drying cycle.
▶ Empty the water tank
▶ Clean the lint filter
▶ Clean the condenser filter
1. Pull out the water tank from its housing. Hold the
tank horizontally (fig.: 34).
2. Empty the water tank into a sink (fig.: 35).
3. Reinstall the water tank to the tumble dryer. (fig.:
36).
The tank can also be emptied during program. To con-
tinue the program the “Start/Pause” button has to be
pressed after the tank has been reinstalled.
The symbol
only switches off after the appliance
was turned off.
34
35
36
Notice
The condensed water can also be derived by a drain hose (enclosed or as an optional
accessory available at the customer service). The tank needs no longer be emptied (see
section ACCESSORY).
After drying
The tumble dryer stops operation automatically when a dry cycle is complete.. The display
shows
END
.
27
28
Notice
The last part of the drying cycle occurs without heat (cool down cycle) to ensure re-
maining the garments at a temperature which does not damage them.
1. Press “On/Off“ button to switch off the appliance.
(fig.: 27).
2. Remove laundry as soon as possible to go easy
on it and to prevent more wrinkling (fig.: 28). If the
laundry is not removed the anti-crease program
starts automatically. In anti-crease phase, the
drum will rotate 30 sec. in each 5.5 minutes, the
total phase time will last for 1 hour.
3. Unplug the power cord
(fig.: 29).
4. Empty the water tank
(fig.: 30).
5. Clean the lint filter in the filling opening
(fig.: 31).
6. Clean the condenser filter
(fig.: 32).
7. Open the door to prevent formation of moisture
and odours. Let it open while not used (
fig.: 33).
29
30
31
32
33
Standby mode / power- saving mode
The switched on appliance will go into standby-mode if it will not be activated within 5
minutes before starting the program or at the end of program. This saves energy. To in-
terrupt the standby-mode push the “On/Off button.