Haier HD80-26A User Manual - page 20
CLEANING & CARE
TUMBLE DRYER
Wipe the outside of the tumble dryer and the control panel with a damp cloth. Do
not use any organic solvent or corrosive agent to avoid damage to the device.
DRUM
After some operation time, fabric care agents or calcium contained in the water
some detergent to remove it. Do not use any organic solvent or corrosive agent
to avoid damage to the device.
EVAPORATOR
a vacuum cleaner. Make sure not to damage the evaporator while cleaning it.
ERROR CODES
CODE
CAUSE
SOLUTION
F2
Drain pump error.
Contact the customer service.
F32,
F33
The condenser thermal
sensor is open-circuited or
short-circuited.
Contact the customer service.
F4
Temperature of the laundry
in the drum does not
change.
Contact the customer service.
E6
E7
Under voltage or over
voltage fault.
Check the voltage of power suply.
Or contact the customer service.
E8
reduce the load,Repower the dryer.
Over load warning.
Lo
Use the dryer when air temperature
is higher than 2
.
Temperature is too low.
The filters is clogged.
Clean both filters.
20 | English
Or contact the customer service.
Check the voltage of power suply or
If the evaporator behind the condenser filter is dirty, it can be cleaned by use of