Haier HDY-HMS70 Operation Manual - page 8
Trouble shooting
The following must be confirmed before calling for service:
Problem
The dryer does not start
Possible Cause
ƽIs the power supply plugged in and switched on.
ƽ Plug another appliance into the wall socket to
test if there is power.
ƽ
ƽ the Start/Pause button has been pressed;
ƽ The water collection box is full;
The drying result is not
good and the drying time
is too long.
ƽIs the drying program setting correct;
ƽHas the filter screen been cleaned ;
ƽIs the condenser blocked;
ƽ Does the amount of the loaded laundry
exceed the rated load;
ƽ Has the loaded laundry been spun dry;
ƽIs the vent duct blocked;
ƽ Has the surface of the inside of the drum
got a deposit layer forming, if so clean the
drum interior;
The remaining time display
is halted, or the remaining
time displayed is skipping
The remaining time will be adjusted and corrected
continuously and automatically based on the
following factors:
ƽType of laundry;
ƽLoaded amount;
ƽThe degree of spinning dry of laundry;
ƽAmbient temperature;
The automatic adjustment is a normal operation.
Trouble shooting
E2
E5
E6
Prompt and Alarm Information
In case of an improper operation or trouble with the machine when it operates, the
code corresponding to the trouble will be displayed on the screen:
Code
Category
Cause
Solutions
Trouble code
Trouble code
Trouble code
There is no change in
the temperatures of
the laundry in the tub
Contact a professional
serviceman
The thermal sensor
open-circuited or short
circuited
Contact a professional
serviceman
Drain pump fails
Contact a professional
serviceman
Start the dryer,but it does
not start and the screen
displayed “End”.
Is the door closed tightly;
ƽThe loaded laundry has reached the requirmrnts
for the drying setting.
ƽIs there load into the tub;