Haier HLF11P User Manual - Installation In Mobile Home

Other manuals for HLF11P: User Manual
Manual is about: Haier HLF11P: User Manual

Summary of HLF11P

  • Page 1

    ® what the world comes home to tm electric dryer user manual- model # hlf11p.

  • Page 2

    Important safety instructions warning – to reduce the risk of fire, electric shock, or injury to persons when using your appliance, follow basic precautions, including the following: 1. Read all instructions before using the appliance. 2. Do not dry articles that have been previously cleaned in, was...

  • Page 3: Save These Instructions

    2 16. This dryer must be properly installed in accordance with the installation instructions before it is used. See grounding instructions in the installation section. 17. Proper grounding must be ensured to reduce the risk of electric shock and fire. Check with a qualified electrician or service pe...

  • Page 4: Table of Contents

    Table of contents page safety instructions ............................................................................1 operating instructions ............................................................4 understanding the control panel ............................................................4 ...

  • Page 5: Operating Instructions

    4 english operating instructions understanding the control panel power on/off button: (1) • press the button once to operate the dryer. Press the button once again to turn the dryer “off”. Start/pause button: (2) • press this button once to start the dry process. Press this button once again to paus...

  • Page 6

    5 english more time & less time button: (6) • set time from 0 to 180 minute when timed dry or rack dry selected. Cycle buttons: (7) • “cycle” button will let you select your desired dry cycles. For your convenience, there are seven fabric care dry cycles programmed in this mode: customized, normal, ...

  • Page 7

    English 6 function light indicator: • the function “display light” indicates selected feature is “on” or the cycle is about to begin. • during the dry cycle, “flashing light” indicates current running program. • rapidly flashing light indicates that the dryer is not operating properly. Preparations ...

  • Page 8: Auto Dry Cycle

    7 english load clothes into dryer auto dry cycle and timed dry cycle • the appropriate load is 1/3 to 1/2 of the drum volume. Avoid to overload the dryer, as space is needed to allow clothes to tumble for uniform and wrinkle proof drying. • when drying big articles, only 2-3 pieces should be loaded ...

  • Page 9

    English 8 • various button initial status for “normal program.” 2. Press “cycles” button to select a suitable full automatic cycle • the normal program will be automatically selected after powering the unit “on”. If other full automatic program is desired, press “cycle” button until corresponding in...

  • Page 10

    9 english 3. Press “dryness level” button to select a suitable drying time • after powering on, the clothes dryer automatically sets dryness at “more dry.” if other drying time is desired, press “dryness level” button to select a shorter time. 4. Press “temp” button to set a suitable drying temperat...

  • Page 11

    English 10 timed dry cycle 1. Press “power on/off” button to power on. 2. Press “timed/cycles” button and select “timed dry” cycle. 3. Press “more time” and “less time” buttons to set a suitable dry time. 4-7. Press buttons “temp,” “cycle signal,” “delay start,” and “wrinkle care,” to define your de...

  • Page 12

    11 english rack dry cycle 1. Press “power on/off” button to power on. 2. Press “timed/cycles” button and select “rack dry” cycle. 3. Press “more time” and “less time” buttons to set a suitable dry time. 4-7. Press buttons “temp,” “cycle signal,” “delay start,” and “wrinkle care,” to define your desi...

  • Page 13: Normal Operating Sounds

    English 12 following sounds are normally heard during the operation of the dryer. • tumbling sounds. This is normal as the heavy wet clothes in the dryer are continuously being tossed around. • air rushing noise. This happens as the dryer drum spins at very high rpm and the air is rushing through th...

  • Page 14: Care and Cleaning Guide

    13 english • lint filter needs to be cleaned before or after each use for your unit to operate at optimum efficiency. The filter can be slid out, by pulling on the tab located on the inside of the dryer door. The filter may be washed or vacuumed. Remove the excess water from the filter by gently sha...

  • Page 15: Troubleshooting

    English 14 dryer does not operate: • check if unit is plugged in. The plug may have come loose. • check if the electrical wall receptacle is of proper voltage. • check if the circuit breaker needs to be reset or if the fuse needs to be replaced. • check if the unit is in “off” mode. Press start butt...

  • Page 16: Tools and Materials Required

    15 english select a suitable location for the dryer on a hard even surface away from direct sunlight or heat source e.G. Radiators, baseboard heaters, cooking appliances etc. Any floor unevenness should be corrected with the leveling legs located on the bottom of the dryer. • phillips head and flath...

  • Page 17: Warning

    English 16 the following are specific requirements for proper and safe operation of your dryer. Failure to follow these instructions can create excessive drying times and fire hazards. Warning 1. Do not use plastic flexible duct to exhaust the dryer. Excessive lint can build up inside exhaust system...

  • Page 18: Materials

    17 english materials use only 4 inch (10.2 cm) diameter (minimum) rigid or flexible metal duct and approved vent hood which has a swing-out damper hat open when the dryer is in operation. When the dryer stops, the dampers automatically close to prevent drafts and the entrance of insects and rodents....

  • Page 19

    English 18 after installation is completed, the following method must be used to determine if the exhaust system is acceptable: 1. Connect an inclined or digital manometer between the dryer and the point the exhaust connects to the dryer. 2. Set the dryer timer and temperature to air fluff (cool dow...

  • Page 20: Location of Your Dryer

    English 19 do not install your dryer: • in an area exposed to dripping water or outside weather conditions. • in an area where it will come in contact with curtains, drapes, or anything that will obstruct the flow of combustion and ventilation air. • on carpet. Floor must be solid with a maximum slo...

  • Page 21: Installation In Mobile Home

    English 20 • dryer must be exhausted outside (outdoors, not beneath the mobile home) using metal ducting that will not support combustion. Metal ducting must be 4 inches (10.16 cm) in diameter with no obstructions. Rigid metal duct is preferred. • if dryer is exhausted through the floor and area ben...

  • Page 22: Warnings

    21 english 1. This appliance must be properly grounded. Electrical shock can result if the dryer is not properly grounded. Follow the instructions in this manual for proper grounding. 2. Do not use an extension cord with this dryer. Some extension cords are not designed to withstand the amounts of e...

  • Page 23: 3-Wire Cord Connections

    English 22 1. Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner. 2. Install a u.L. Approved strain relief into the power cord entry hole of the mounting bracket. Finger tighten the nut only at this time. 3....

  • Page 24: 4-Wire Cord Connections

    4-wire cord connections (not included) 1. Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner. 2. Install a u.L. Approved strain relief into the power cord entry hole of the mounting bracket. Finger tighten t...

  • Page 25

    4. Thread a u.L. Approved 30 amp power cord, nema 14-30 type st or srdt through the strain relief. 5. Attach the green power cord ground wire to the cabinet with green ground screw. 6. Attach the white (neutral) power cord conductor from the power cord and the green ground wire from the dryer harnes...

  • Page 26: Limited Warranty

    Limited warranty full one year in-home warranty for 12 months from the date of original retail purchase, haier will repair or replace any part free of charge including labor that fails due to a defect in materials or workmanship. Limited warranty after one year from the original retail pur- chase da...

  • Page 27: Important

    ® what the world comes home to tm hlf11p issued: february - 04 important do not return this product to the store if you have a problem with this product, please contact the "haier customer satisfaction center" at 1-877-337-3639. Dated proof of purchase, model # and serial # required for warranty ser...