Hoggi BINGO User Manual - page 30
29
7 Maintanance
Your BINGO rehab puschair is CE approved. The manufacturer herewith guarantees that this medical
product as a whole conforms to the requirements of 93/42/EEC Guideline.
The rehab puschair should be checked for correct function before every use.
The items listed in the following table must be checked by the user at the indicated intervals. Failure to carry
out these simple checks may lead to problems arising that could invalidate the warranty.
Check
daily
weekly
monthly
Function test of the brake/wheel lock
X
Check of screw connections
X
Air pressure (indicated on the side wall of the tyre)
X
Visual inspection of wearing parts such as wheels and bearings
X
Contamination on bearings
X
Should any defects become obvious, please contact your authorized HOGGI dealer to eliminate them. We also
recommend that you have your BINGO serviced by your authorized dealer every twelve months.
Instructions for Cleaning and Maintenance
- Clean all frame components and plastic parts using mild detergents only.
- Padding parts can be washed at 40 °C. If washed in a washing machine, put them in a linen
bag or a pillow case.
- In most cases, wiping with a damp cloth is sufficient.
- Do not use your BINGO rehab pushchair in salt water.
- Keep sand or other particles from damaging the wheel bearings.
Attention!
We recommend that, wherever and whenever possible,
users transfer to the seats installed in the motor vehicle
and use the corresponding vehicle restraint systems,
because this is the only way to ensure optimum protection
of the passengers in case of an accident.
Your BINGO Rehab Pushchair was successfully tested in
accordance with ANSI/RESNA WC/19 and ISO 7176/19
(Crash Test).
It is, however, possible to use your BINGO Rehab
Pushchair as a seat in a motor vehicle, if our “Tie down
Kit” (article 3201-7300) as well as appropriate restraint
systems are used.
This Rehab Pushchair is equipped with back angle and
seat tilt adjustment. Before starting you must tilt the
backrest until the lock pin (A) locks into the hole (B) in the
back plate. Tight the lever (C) well after this adjustment.
Using the seat tilt adjustment you must bring the backrest
into almost upright position (max. 20°). Observe the
specifications under 4.6 and 4.13 in this user manual.
6.2 Using BINGO Rehab Pushchair for Bus Transport
B
A
C