Home Automation OmniTouch 53A00-1 Installation Manual - page 10

8 

CONNECTING TO OMNI IIe, LUMINA, OMNIPRO II, AND LUMINA PRO 

Connect the "Yellow" and "Green" wires from the touchscreen to the "A" and "B" terminals 

under the section marked "CONSOLE" on the controller, respectively.  Connect the "Red" and 

"Black" wires from the touchscreen to the "12V" and "GND" terminals under the section 

marked "AUXILIARY" on the controller, respectively.   

A maximum combination of 8 touchscreens and consoles can be used with Omni IIe or Lumina 

and a maximum combination of 16 with OmniPro II or Lumina Pro. 

NOTE: Do not exceed the maximum current limitation of the controller.  If more than 2 

touchscreens are used, the additional touchscreens must be powered from an external 

power supply or HAI Touchscreen Hub. 

THE EXTERNAL POWER SUPPLY MUST BE GROUNDED TO THE CONTROLLER 

EARTH GROUND TO AVOID DAMAGE TO THE TOUCHSCREEN. 

GR

EE

N

YE

L

LOW

BL

AC

K

RE

D

CONNECT ENDS OF SUPPLIED

CABLE TO CORRESPONDING ENDS

OF THE POWER/COMMUNICATION

CABLE FROM THE CONTROLLER

YELLOW

GREEN

BLACK

RED

(PLUGS INTO J1)

SUPPLIED CABLE

Omni IIe, Lumina, OmniPro II, and Lumina Pro Connections