Home Automation OmniTouch 53A00-1 Installation Manual - page 12

10 

ADDRESSING THE TOUCHSCREEN 

OmniTouch touchscreens are connected to the same communications bus as HAI consoles.  

Each console and touchscreen must have a unique address.  The default address setting of the 

touchscreen is "1".   

When power is first connected to the touchscreen, if the touchscreen isn’t addressed properly 

(other consoles or touchscreens already occupy the touchscreen address) or isn’t communicating 

with the controller, the following page is displayed. 

To assign an address to the touchscreen, press and hold the HAI logo for three seconds.  The 

"Touchscreen Address" page is displayed.   

This page allows the installer to adjust the brightness and contrast of the touchscreen, enable or 

disable video, and assign the touchscreen address.