Home Protector 4AHD Quick start manual - Getting to Know Your Dvr
1
1
Getting to Know your DVR
This quick start guide will help you to get your CCTV kit up and running as quickly as
possible.
We suggest you connect up the kit to familiarise yourself with it before installing the
cameras in their permanent location.
Before installation please check you have all the kit contents listed below and read
the following safeguards and warnings carefully.
1. Video In x 4 (BNC) - connects your cameras
2. HDMI - connects a TV/Display with HDMI input
3. VGA - connects a TV/Monitor with VGA input
4. USB 1 (upper USB 2.0 port) - connects a mouse
5. USB 2 (lower USB 2.0 port) external storage device
6. LAN - connects to your home network
7. Power In - use to connect to the power adaptor
Kit Contents: 1 x DVR • 4 x Video cameras (inc. cable and fixings) • 4 x 18m Video/power cables
• 1 x 12V
𝌂
4A Power adaptor • 1 x Mouse • 1 x HDMI cable • 1 x RJ45 Ethernet cable
Important Safeguards and Warnings
• Do not place heavy objects on top of the DVR.
• Do not let any liquids spill on the DVR.
• Gently brush clean the DVR surfaces regularly. Before cleaning please switch off and
disconnect the power supply.
• Do not disassemble or attempt to repair the DVR by yourself. If repair is necessary please
contact the reseller or a qualified specialist.
• Make sure any outdoor electrical connections are adequately sealed / waterproofed
Environment
• Ensure the DVR is installed in an appropriate temperature environment; min 0˚C, max 40˚C.
• Avoid direct sunlight and install away from any direct heat source.
• Do not install the DVR in a damp, smoky or dusty environment.
• Instal in a safe position where the DVR will not be damaged.
• Ensure the DVR is installed in a stable work environment.
• Install in a well ventilated and clean location.
• Always use within the recommended input and output rating.
Fig. 1 DVR Connections
1
6
3
2
4
7
5