HoMedics ELLE MACPHERSON Instruction Manual - page 5
5
G
B
Switching the device on and off
- The on/off switch is located in front of the Pedicure unit (See Figure 1, part A).
- Slide up switch to the “1” or “2” position to turn ON and slide back to “0” position to turn OFF.
- The pedicure unit has 2 speeds , position “1” is Low speed , position “2” is High speed.
How to attach the pedicure attachments
• All the attachments fit simply on to the magnetic fitment rod (see figure 1).
• To connect the attachments to the pedicure unit, directly insert them into the magnetic fitment rod, so that
the metal pin of the attachment is inside the cylinder of the magnetic fitment rod. It may be necessary to
slightly twist the attachment to ensure it clicks into place.
• The metal pin of the two large abrasive rollers are inside the attachment and these fit over the fitment rod
like a sleeve.
• To remove the attachments, simply pull out away from the product.
• The transparent guard(B) is optional during operation, the angle of fitment can be adjusted to minimise
mess from dead skin and filed nails by localising the mess and avoiding the deposits covering a large area.
• It is supplied already fitted, but can be removed or adjusted by simply unfixing the attachment first and
then pulling the transparent guard out away from the product. Then either put safely to one side, or
pushing back into place at the desired angle.
• The guard should always be attached before fixing the pedicure tool into the magnetic fitment rod.
Correct use of the attachments
Skin care attachments – High speed (setting 2) is recommended for smoothing the skin
- Large 40mm abrasive roller (C) is used for hardened and callused skin removal on the heels, soles or other
large areas of the feet.
- Small 12.5mm abrasive roller (D) is used for removing the hardened and callused skin in between the gap
of the toes or other more precise treatment areas.
- Sapphire grain cone (E) can also be used for removing hardened and callused skin as required
Nail Care attachments – Low speed (setting 1) is recommended for nail treatment
• Sapphire disk (G) is used for shortening and shaping nails.
• Sapphire grain cone (E) - can be used for filing and finishing nails
• Small Cylinder shaper (H) – for treating cuticles and corners of nails where greater precision is required.
• Felt Cone (F) - for polishing nails at the end of the pedicure.
• Adjustable transparent guard (B)is to avoid the pedicure residue creating a mess during pedicure
treatment.
Maintenance and Storage
• Only a damp cloth should be used to clean the pedicure unit and its attachments
• Store batteries away from metal objects.
• Remove batteries if equipment is not going to be used for extended periods of time.
• Store batteries in a cool dry place away from direct sunlight.
IB-PED500EU-0313-01_Layout 1 27/03/2013 14:00 Page 5