I-Inc CY199D User Manual - page 3
3
Detaching LCD Monitor from Its Stand
Unscrew screws n the swivel base support column and pull downo
the hinge to release.
2
1
D VI -D
Interface for Arm Applications
Before installing to mounting device, please refer to Fig.1-3.
The rear of this LCD display has four integrated 4 mm, 0.7 pitches
threaded nuts, as well as four 5 mm access holes in the plastic covering as
illustrated in Figure 1-4. These specifications meet the VESA Flat Panel
Monitor Physical Mounting Interface Standard (paragraphs 2.1 and
2.1.3, version 1, dated 13 November 1997).
Note :Please using M 4mm x 10mm (L) screw for this
application.
100mm
100mm
100mm x 100mm
Screw Mounting Options
4mm ,0.7pitch
threaded holes x4
DVI-D
Figure 1-4
Connecting the Display
1.
Power off your computer.
2.
Connect one end of either the VGA or DVI cable from the PC to
the LCD Monitor’s matching VGA or DVI port (see fig 1-5)
3.
Make sure connections are secure.
VGA Port
DVI Port
DVI-D
Connecting the AC Power
1.
Connect the power cord to the LCD Monitor.(See Fig. 1-6)
2.
Connect the power cord to an AC power source.
AC Power Jack
Power Cord
DVI-D
Connecting the Audio Cable
1.
Connect the audio cable to the "LINE OUT" jack on your PC's
audio card or to the front panel's “AUDIO OUT” jack of your CD
ROM drive. (See Fig. 1-7)
2.
Connect the other end of the audio cable to the LCD Monitor's
"LINE IN" jack.
Audio Jack
DVI -D
Setting Up the LCD Monitor
1.
Make sure the
AC power cord is connected to the LCD Monitor.
2.
Turn on the LCD Monitor's power switch, located on the bezel of the monitor.
Power Management System
This LCD Monitor complies with the VESA DPMS (version 1.0) Power Management guidelines. The VESA DPMS provides
four power saving modes through detecting a horizontal or vertical sync. signal.
When the LCD Monitor is in power saving mode, the monitor screen will be blank and the power LED indicator will light
yellow.
Figure 1-7
Figure 1-5
Figure 1-6
Figure 1-3