I-MO 200-D Series Installation Manual - page 11
EMS i-MO 200-D Series Hardware Installation Guide
Version
2.0
ELECTRONIC MEDIA SERVICES LIMITED
PASSFIELD BUSINESS CENTRE, LYNCHBOROUGH ROAD, LIPHOOK, HAMPSHIRE, GU30 7SB, UK
Tel: 01428 751655 | Fax: 01428 751654 | E-mail: imo@ems-uk.com
Page
11
of
20
6) How to attach the default 3G/4G 'Type C Stub' antennas
Up to 2 antennas may be provided dependent upon the number of modems installed. Each aerial should be
attached to the aerial sockets as shown below.
Note: Connectors should be touch tight only! Do not over tighten.
To attach optional external aerials please refer to
Connecting the External Antennas to the i-MO
for details.
7) How to attach network and ADSL cables (optional)
The i-MO appliance provides two Ethernet ports at the rear. Each of these can be individually configured as
WAN or LAN ports.
Network cables (not provided) can be connected as shown below.
The default
configuration is all ports configured for LAN usage (2 port network hub). There are also two ADSL ports and
ADSL cables can be connected as shown below in image
2
.
Note: The Serial port at the rear of the unit is a Console (RS-232) Port available for unit configuration
purposes only.
8) How to attach the power cable
The appliance is powered by an AC Adapter power supply. Do not connect the power supply to the mains
yet. Please insert the power cable as shown below. Now connect power supply to mains.
Note: We recommend the use of UPS units where power regulation cannot be guaranteed (e.g. use of a
generator)