I-MO 200-D Series Installation Manual - page 14
EMS i-MO 200-D Series Hardware Installation Guide
Version
2.0
ELECTRONIC MEDIA SERVICES LIMITED
PASSFIELD BUSINESS CENTRE, LYNCHBOROUGH ROAD, LIPHOOK, HAMPSHIRE, GU30 7SB, UK
Tel: 01428 751655 | Fax: 01428 751654 | E-mail: imo@ems-uk.com
Page
14
of
20
Appendix A - WiFi Radio Component
Warnings
When using the device, ensure that the antenna of the device is at least 1 cm away from all persons.
Do not use the device where using wireless devices is prohibited or may cause interference or danger.
Do not operate the WiFi device in areas where blasting is in progress, where explosive atmospheres may be
present, near medical equipment, life support equipment, or any equipment which may be susceptible to any
form of radio interference. In such areas, the WiFi device MUST BE POWERED OFF. It can transmit signals
that could interfere with this equipment.
Do not operate the WiFi device in any aircraft, whether the aircraft is on the ground or in flight. In aircraft, the
WiFi device MUST BE POWERED OFF. When operating, it can transmit signals that could interfere with
various on-board systems.
Regulatory Notices
The design of the WiFi device complies with U.S. Federal Communications Commission (FCC) guidelines
respecting safety levels of radio frequency (RF) exposure for mobile devices, which in turn are consistent
with the following safety standards previously set by U.S. and international standards bodies:
ANSI / IEEE C95.1-1999, IEEE Standard for Safety Levels with Respect to Human Exposure to
Radio Frequency Electromagnetic Fields, 3kHz to 300 GHz
National Council on Radiation Protection and Measurements (NCRP) Report 86, 1986, Biological
Effects and Exposure Criteria for Radio Frequency Electromagnetic Fields
International Commission on Non-Ionising Radiation Protection (ICNIRP) 1998, Guidelines for
limiting exposure to time-varying electric, magnetic, and electromagnetic fields (up to 300 GHz)
FCC ID: N7N-MHS802
RF Exposure - This device has been tested for compliance with FCC RF exposure limits in a portable
configuration. At least 1.0 cm of separation distance between the WiFi Antenna and the user's body must be
maintained at all times. This device must not be used with any other antenna or transmitter that has not been
approved to operate in conjunction with this device.
WARNING (EMI) - United States FCC Information - This equipment has been tested and found to comply
with the limits for a Class B computing device peripheral, pursuant to Parts 15 and 27 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in
accordance with the instructions, it may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.