I-onik WS-210TX Quick Start Manual - page 6
10
11
4
Press
to complete
the enrolment.
Confirm the enrolment and
return the Smart Panel to
STANDBY by pressing
.
2.3. Operating the Key Fob Remote Control
ARM – Pressing the ARM button on the remote will arm the system, triggering the preset
exit delay. When triggered the Smart Panel’s LED light will flash red and indicate the
triggered zone.
DISARM – Pressing the DISARM button on the remote will disarm the system instantly
and the system will return to STANDBY Mode.
AlERt – Pressing the ALERT button on the remote will put the system into ALERT Mode
and a chime will sound if any of the sensors are triggered. The green light on the Smart
Panel LED display will flash and indicate the triggered zone.
HOME – Pressing the HOME button on the remote will set the system in HOME Mode
which will operate the system in both ARM and ALERT Modes in different preset zones.
PAnIC – If the HOME and ALERT buttons are pressed together the system‘s alarm is
immediately activated.
2.4 Deleting a Remote Control from the Smart Panel
If a remote control device is damaged or lost, it can be deleted from the system as
follows:
- The Smart Panel will display
the image below when you
are in STANDBY mode:
(One beep indicates that you
entered a valid PIN, three
beeps indicate that an invalid
operation was performed).
2
(1234/
4-digit PIN)
+
Enter the default
PIN “1 2 3 4” OR
your new 4-digit PIN
for setting followed
by
The Smart Panel will display
the below image:
3
Press
then
to enter the Remote
Control Enrol mode.
Then press any key
on the new remote
control to enrol it
onto the system.
LCD display flashes the ID
no. of the remote to be en-
rolled e.g. when enrolling the
first remote ID no. “01” will
flash. Once the first remote
is enrolled the “02” will flash
ready for a second remote
to be enrolled. (One beep
indicates that the remote
was enrolled to the Smart
Panel successfully.)
note: It is recommended
that the ID no. is marked
on the remote in case it
needs to be deleted at a
later stage.
Step
Keys
Description
note
1
(1234/
4-digit PIN)
+
You must be in
STANDBY mode
before enrolling a
new remote control
onto the Smart
Panel.
To make sure you are in
STANDBY mode:
- Enter the default PIN
“1 2 3 4”OR your new
4-digit PIN
- Press