I-onik WS-210TX Quick Start Manual - page 8
14
15
3. Maintenance
The product may be cleaned with a soft damp cloth and then wiped dry. Do not use
abrasive, solvent based or aerosol cleaners as this may damage and/or discolour the
product. Do not allow water to enter or attempt to clean inside the unit.
4. Batteries
Do not allow the batteries to corrode or leak as this may cause permanent damage to the
product. Take care to insert the batteries with the correct polarity as shown inside the
battery compartments. Do not mix new and old batteries or different types of batteries.
Do not use rechargeable batteries.
At the end of their useful life the batteries should be disposed of via a suitable recycling
centre. Do not dispose of with your normal household waste. DO NOT BURN.
5. Alarm System limitations
Even the most advanced alarm systems cannot guarantee 100 % protection against
burglary or environmental problems.
All alarm systems are subject to possible compromise or failure-to-warn for a variety of
reasons.
Please note that you may encounter problems with your system if:
• The Smart Panel is not placed within hearing range of persons sleeping or remote parts
of the premises.
• The sensors are placed behind doors or other obstacles.
• Intruders gain access through unprotected points of entry (where sensors are not
located).
• Intruders have the technical means of bypassing, jamming, or disconnecting all or part
of the system.
• The power to the sensors is inadequate or disconnected.
• The sensors are not located in proper environmental/temperature conditions i.e. too
close to a heat source.
note:
Inadequate maintenance is the most common cause of alarm failure; therefore,
test your system at least once per week to be sure the sensors and sirens are
working properly.
Although having an alarm system may make you eligible for reduced insurance
premiums, the system is no substitute for insurance.
3
Press
then
to go into Remote
QUERyINg mode,
and then press any
key on the remote to
check its ID.
- After entering into Remote
QUERyINg mode, the LCD
display will flash the total
number of remote controls
currently enrolled to the
system (e.g. if 3 remotes are
enrolled the LCD display will
flash “03”).
- The ID no. of the remote
can then be checked by
pressing any key on the re-
mote (e.g, if the LCD display
flashes “02” then that is the
ID of the remote).
4
Press
to complete
the query.
Complete the query and
return the Smart Panel to
STANDBY by pressing
.