I.safe MOBILE innovation 2.0 Quick Start Manual - I.Safe Mobile
i.safe MOBILE
Safety Instruc ons
8
4 Ex-relevant Safety Regula ons
Use of this phone assumes that the operator observes the conven onal
safety regula ons and has read and understood manual, safety instruc-
ons and cer ficate.
The following safety regula ons must also be complied with:
·
Inside ex-hazardous areas the phone must be closed. The ba ery has
to be fixed by the two screws and the cover of the USB interface has
to be closed.
·
To ensure the IP-protec on, it has to be ensured that all gaskets are
present and func onal. The screws at the top and the bo om of the
back of the phone need to be covered by the black gaskets, so that
the screw heads are not visible. There must be no large gap between
the two halves of the housing. IP protec on is not guaranteed any-
more if the yellow housing can be seen in the gap of the black hous-
ing material.
·
The ba ery may only be exchanged or charged outside ex-hazardous
areas.
·
The phone may only be charged outside ex-hazardous
areas using the i.safe PROTECTOR USB-cable or other equipment ap-
proved by i.safe MOBILE GmbH.
·
USB-connec ons to other equipment are only allowed outside ex-
hazardous areas using the i.safe PROTECTOR USB-cable or other
equipment approved by i.safe MOBILE GmbH.
·
Use only the appropriate ba ery type BPI02A.
·
It is not allowed to carry spare ba eries into ex-hazardous areas.
·
The phone may be charged only at temperatures in between 0°C ...
45°C.
·
The phone must not be exposed to abrasive acids or bases.
·
The phone must not be taken into zones 0 or 20.
·
Only accessories approved by i.safe MOBILE GmbH may be used.