I-SENS TEE2 Owner's Booklet - page 6
8
www.i-sens.com
www.spirit-healthcare.co.uk
9
The TEE2 Meter comes with two 3.0 V lithium batteries.
Before using the meter, check the battery compartment and
insert batteries if empty.
When using your meter and seeing the
symbol appear on the
display for the first time, the batteries should be replaced as soon as
possible. The test results might not be saved if the batteries run out.
Inserting or Replacing the Batteries
Note:
•
Removing the meter batteries will not affect your stored
result. However, you may need to reset your meter settings.
See pages 14-16 .
Caring for Your System
Use a soft cloth or tissue to wipe the meter exterior. If necessary,
the soft cloth or tissue might be dipped in a small amount of
alcohol.
Do not use organic solvents such as benzene, or acetone, or
household and industrial cleaners that may cause irreparable
damage to the meter.
Caution:
• Do not expose the meter to direct sunlight heat, or excessive
humidity for an extended period of time.
• Do not let dirt, dust, blood, or water enter into the meter’s
test strip port.
• Do not drop the meter or submit it to strong shocks.
• Do not try to fix or alter the meter in any way.
• Keep the meter away from strong electromagnetic fields
such as cell phones and microwave ovens.
• TEE2 meter should be used only with TEE2 strips.
• Keep the meter in a cool and well ventilated place.
• Store all the meter components in the portable case to
prevent loss and help keep the meter clean.
Step 1
Make sure the meter is turned off. Push the
cover in the direction of the arrow to open
the battery compartment.
Step 2
Remove the old batteries one by one by
lifting with the index finger and pulling it
out with your thumb and index fingers as
shown in the figure on the right. Insert two
new batteries with the + side facing up and
make sure the batteries are inserted firmly.
Step 3
Place the cover on the battery
compartment. Push down until you hear
the tab click into place.