I-Sniper EL-750 Installation Manual

Manual is about: VANDAL DAY/NIGHT DOME CAMERA

Summary of EL-750

  • Page 1

    Installation manual please read this manual carefully before installation and operation of the product. 130809-1 powered by vandal day/night dome camera el-750 i-sniper vandal day/night dome camera copyright 2013, ic realtime, llc. Made in korea. · el-750

  • Page 2

    1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8. Do not install n...

  • Page 3

    · please read the manual carefully before the installation in order to make use the camera to be set up correctly and to have the best picture quality. · please keep the manual in good condition for your future reference and service application. · installation and services should only be carried out...

  • Page 4

    6 7 installation manual el-750 please read this manual carefully before installation and operation of the product. Powered by i-sniper vandal day/night dome camera 5. Main features 3. Disclaimer of warranty 4. Package in no event shall seller be liable to any party or any person, except for replacem...

  • Page 5

    8 9 6-1. Installation a. Surface mount 6. Assembly overview bnc female for video dual power (12v dc/24v ac) mounting screws m4*30l-3ea torx screws m4*10l-3ea plastic anchors(if needed) Ø4*30l-3ea drilling template assembly surface bottom assembly dome cover rs-485 ① paste a drilling template on the ...

  • Page 6

    10 11 a. Power cable b. Rs-485 : same as above c.Video output cable (red) (black) * caution please make sure to seal these places with a tape tightly enough to prevent water smearing into the cable. A lot of actual damages are happening by doing improper finish on the spot. 6-3. 3-axis, lens adjustm...

  • Page 7

    12 13 7. Troubleshooting problems troubleshooting nothing appears on the screen. · please check that the power cord and line connection between the camera and the monitor are fixed properly. · please check that you have properly connected video cable to the camera. · video output jack. Check dc iris...

  • Page 8

    14 15 8. Specification 7. Dimension(mm) ■ specifications are subject to change without prior notice to enhance performance and stability. General image sensor 1/3”pixim wdr digital image device effective pixels 410,000 pixels 758 (h) x 540(v) h.Resolution 690htvl effective synchronizing system inter...

  • Page 9

    16 17 10. Osd manual for functions control osd menu tree icrealtime wdr control low normal middle high blc off on agc low normal high white balance atw awb.. Fluorescent off crr crr2 icr dvr tool off edge series max series flex series elite series rs-485 camera # protocol baud rate return flip off b...

  • Page 10

    18 19 5. Fluorescent color rolling reduction (crr) off : not used crr. Crr : this color roll reduction mode will work with manual and auto-iris lenses. However, using it with auto-iris lenses typically results in noticeable levels of noise in shadows or dark areas in the image. Crr2 this color roll ...