I-Sniper EL-750 Installation Manual - page 5
8
9
6-1. Installation
A. Surface Mount
6. Assembly overview
BNC Female
for Video
Dual power
(12V DC/24V AC)
Mounting screws
M4*30L-3EA
Torx screws
M4*10L-3EA
Plastic anchors(if needed)
Ø4*30L-3EA
Drilling template
Assembly surface bottom
Assembly dome cover
RS-485
① Paste a Drilling Template on the ceiling or wall and drill screw points which will be
done for installation.
② Fix a Surface Mounting Base by using Tapping Screws with Ø 4 provided.
③ Point a Camera 3D Gimbal to a desired direction and assemble a dome cover to the
Surface Mounting Base with Torx Screws by using Torx Wrench provided.
B. Junction Boxes
Mounting screws
PH M4*5L & Ø4 O_ring -3EA
Torx screws
M4*10L-3EA
Assembly surface bottom
Assembly dome cover
Electrical junction box
Junction box screws
FH M4*12L -4EA
(UNC 8-32x0.75 screws : not included)
① Fix a Surface Mounting Base and Junction plate Gang Junction Box by using Fixed
Screws with M4 provided.
② Assemble a dome cover to the Base with Torx screws.