C-ax401d1m network camera user guide warning: before attempting to connect or operate this product, read these instructions carefully. Save this manual for future use. To avoid electrical shock and to preserve the product warranty, do not disassemble the camera. Refer servicing to qualified personne...
Precautions this equipment has been tested and found to comply with the limits for a class a digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This ...
Notes of use power supply ensure the supplied voltage meets the power consumption requirements of this camera before powering the camera on. Incorrect voltage may cause irreparable damage to the video camera and will effectively void the camera warranty operating or storage location avoid shooting v...
Notes of use network connector alarm in(red:in/orange:gnd) audio in(white) power(white:-/black:+) alarm out(yellow:out/black:gnd) audio out(black) tv / ip select reboot button horizontal adj ring tu rn t he r ing to adjust th e horizontal angle of image. Tilt adj screws turn the screws to adjust the...
Mounting installation step 3: loosen the locking screw. To remove the cover, rotate the cover counter clockwise. Step 4: mount the camera to the ceiling/wall step 1: adhere the guide pattern to the installation surface. Drill one big and three small holes, using the template as a guide. Step 2: feed...
Mounting installation step 6: align the notch with position “p”. Rotate the cover clockwise to lock the cover to the base. Tighten the locking screw. Step 7: turn on the power the camera has no main power switch or button. To turn the power on, insert the plug of the power cord into a power outlet. ...
Networking connecting to a camera using a network 1. Connect the camera to a poe (power over ethernet) enabled switch or router using a rj45 cat5 or cat6 connection cable. 1.1. Connect the users computer to the poe switch or router. Or 1. Connect the camera to a personal computer or a switch or rout...
Networking 4. If you cannot connect try the following: 4.1. Wait. Sometimes the router or switch will take a few seconds to refresh the routing table 4.2. Go to control panel, network connections, and properties of the lan or wan the camera is connected to. Under the internet protocol (tcp/ip) prope...
Specifications the specifications are subjects to be change without notice camera synch system internal image sensor 1/3" progressive transfer ccd number of effective pixels full scanning mode: 1280 (h) x 960 (v) lens f=2.7~9mm, f1.2 frame rate svga 1280x960 @ 15fps vga 640x480, qvga 320x240 @ 30 fp...
Specifications network image compression method mjpeg / mpeg4 protocol tcp/ip, udp/ip, http, smtp, dns, dhcp, ntp, ddns, ftp, rtp connectors 2-pin terminal block interface network port rj45 with leds audio in & out ports 3.5mm phone jack alarm in & out ports 1x alarm in / 1x alarm out 9.
I³ international inc. 1.866.840.0004 www.I3international.Com canada 780 birchmount road, unit 16, scarborough, on, m1k 5h4 u.S.A. 440 lawrence bell drive, suite 16, williamsville ny, 14221.
