IAME X30 SUPER 175CC Basic Manual - page 6
of
9
MAN-78
EXHAUST GAS TEMPERATURE PROBE
The muffler, supplied with the engine is provided with a temperature probe fitting
which is not drilled.
Whenever you wish to employ the probe, please proceed as shown in the figure
below.
EXHAUST LENGTH SETTING
The exhaust length setting depending on the track conditions and needed power
diagram.
In general, by shortening the total exhaust length the low RPM an improvement at
high RPM is achieved and vice versa, by lengthening the exhaust length the low
RPM is improved.
For shortening or lengthen the exhaust, the only thing permitted is use of more
spacers 5mm and seals provided by "IAME".
drill exhaust Ø4.2 for cylindrical probe
drill exhaust Ø4.2 and thread M5 for threaded probe
5