IBall Baton iB-WVG300N User Manual - Tcp/ip Configuration
VDSL2 Gateway Router
8
Chapter 5. Connecting the Router
5.1 System Requirements
VDSL2/ADSL2+/Broadband Internet Access Service
DSL/Cable/Ethernet)
1 DSL/Cable Modem that has an RJ45 connector (which is not necessary
if the Router is connected directly to the Ethernet.)
Computer with a working Ethernet Adapter and an Ethernet cable with
RJ45 connector
TCP/IP protocol on each PC
5.2 Installation Environment Requirements
Place the Router in a well ventilated place far from any heater or heating
vent
Avoid direct irradiation of any strong light (such as sunlight)
Keep at least 2 inches (5 cm) of clear space around the Router
Operating Temperature: 0℃~40℃ (32℉~104℉)
Operating Humidity: 10%~90%RH, Non-condensing
TCP/IP Configuration
The default IP address of the iB-WVG300N VDSL2 Gateway Router is 192.168.1.1
and the default Subnet Mask is 255.255.255.0. These values can be changed as per
the requirement. In this guide, we use all the default values for description.
Connect the local PC to the LAN ports of the Router. The IP address for your PC can
be configured in the following two ways.
Configure the IP address manually
1)
Set up the TCP/IP Protocol for your PC. If you need instructions as how
to configure,