Iccons GT-3 User Manual - A. The Use of Internal
Serious Connections
TM
ICCONS™ GAS TOOL GT-3 & GT-3ST USER MANUAL
2
A. THE USE OF INTERNAL
COMBUSTION, GAS OPERATED
NAILER TOOL
The ICCONS
™
Gas Nailer is referred
to as “tool” in this general safety
instruction.
ICCONS
™ Pty Ltd
is referred to as
“manufacturer” in this general safety
instruction.
Introduction
- Only those fasteners which are
specified in the operating instructions
shall be used in the tool. The tool, the
fastener, the fuel cell and the battery
specified in the operating instructions
are to be considered as one unit safety
system.
- Only spare parts specified by
the manufacturer or his authorized
representative shall be used in the
service or repair of the tool.
- Repairs shall be carried out only by
the manufacturer or his authorized
representative.
- Keep the tool, fasteners, fuel cell,
battery and charger out of the reach of
children.
Safety of the Fastener Driving Tool
- Check prior to each operation that
the safety mechanism is functioning
properly. Rectify any loose fasteners or
defects on the tool before use.
- Only use the tool for nailing
application for which it was designed.
- It is not permitted to make any
modification to the tool, fuel cell or
battery, other than those specified by
the manufacturer.
If the tool is weakened or damaged by:
- Punching or engraving;
- Modification not authorized by the
manufacturer;
- Guiding against templates made of
hard material;
- Dropping or pushing across the floor;
use as a hammer;
- Apply excessive force of any kind;
it should be taken to service and inspect
by the manufacturer or authorized
agents.
- Operator should carry out regular
maintenance (cleaning and lubrication)
in accordance with the operation manual
to keep the tool in good working order.
- The fastener driving tool should
be serviced properly and at regular
intervals in accordance with the
operation manual.
Safety at work
- Make sure the workplace is clean and
well lit.
- Stay alert, watch what are you doing,
and use common sense when operating
the tool. Do not use tool while tired or
under the influence of drugs, alcohol, or
medication.
- Always assume the tool is loaded.
Never point any tool at yourself or at
any other person.
- The tool must be carried pointed
downward while moving locations.
Never carry the tool with your finger on
the trigger.
- Never press your hand on the front of
the tool. The tool must be operated only
when it is in contact with the material to
be fixed.
- The operator must be in a stable
position when using the tool. Operate
the tool in the manner that should the
tool recoil, there is no risk of injury to
the operator.
1. GENERAL SAFETY INSTRUCTIONS