Ice IW80 Operator's & Parts Manual - page 7
OPERATOR
ICE IW80
7
To prevent odors in the tank, remove the power head when machine is not used to
allow air to circulate.
Do not use an extension cord in conjunction with the standard power cord.
6) Turn power switch to "on" position.
7) Use the appropriate tool to pick up the water.
8) During wet pickup, the float shut-off will automatically prevent water from entering the tank once
the tank is full.
If foam develops in the tank during wet vacuuming, use defoamer chemical to help
eliminate the foam. Foam will not activate the float shut-off, and therefore, may
cause vacuum motor damage.
1) If the machine has been used for wet pick-up, empty the tank first. Rinse it out and dry it
completely and install the dry container system. Do not use the machine for dry pick-up without
the dry container system in place.
2) Remove the power head, make sure the dust bag and filter is properly installed.
DRY OPERATION
Do not operate machine to vacuum dust without filter properly installed.
Do not use an extension cord in conjunction with the standard power cord.
6) Turn power switch to "on" position.
7) Use the appropriate tool to pick up the dust.
8) Check the filter bag periodcally to see if it is full. For optimal performance, replace the bag when it
is 3/4 full.
DRAINING THE TANK
1) Unplug machine from power outlet.
2) Transport machine to nearest floor drain or bucket.
3) Remove drain hose from the rear of machine. Remove the ball plug from the hose, then drain the
dirty water from the tank.
4) After the water have drained, remove the power head and rinse the tank with clean water.
5) Reposit the power head. Replace the ball plug on the drain hose and hang hose back on the rear
of the machine.
3) Replace the power head and connect vacuum hose to inlet on the machine body.
4) Attach appropriate accessory tool for the job to be completed.
5) Make sure the switches are in the OFF position, then plug power cord into a grounded outlet.