ICentral 10.2 Premium Installation & Operation Manual - page 13
13
19
MONITOR INSTALLATION GUIDE:
Installation Instructions:
Please select relevant wire diagram for your chosen system
Make sure you use correct cable for system required.
Single Monitor Installations:
Select correct height of indoor monitor
,
usually installation height is between
150~160CM
(
See below Figure 1
)
After determine the monitor bracket position and run cable through the bracket
,
fix
locating screws in bracket.
Finally, install the indoor monitor on the wall as below Figure 2.
19
MONITOR INSTALLATION GUIDE:
Installation Instructions:
Please select relevant wire diagram for your chosen system
Make sure you use correct cable for system required.
Single Monitor Installations:
Select correct height of indoor monitor
,
usually installation height is between
150~160CM
(
See below Figure 1
)
After determine the monitor bracket position and run cable through the bracket
,
fix
locating screws in bracket.
Finally, install the indoor monitor on the wall as below Figure 2.
1. use the recommended cable between all stations.
2. determine the correct height for the Room Station/s. Typical installation height is
between 150-160cm. See figure 1.
3. Run the cable through the bracket and mount the bracket to the wall using screws.
4. Terminate the cable at the monitor following the relevant wiring diagram in this
manual.
5.
Fit the Room Station on the bracket. See Figure 2.
room Station Installation Guide
FIg. 1
FIg. 2