Icom CS-207 Operating Manual

0

I C O M  

OPERATING GUIDE (for IC-207H)

GETTING STARTED

Before using the program, make a backup copy of

To use this program, the following hardware and

the original disk. Operate the program using the

 ba

software are required:

 and keep the original in 

a 

safe p/ace.

l 

IBM PC/AT or 

 compatible computer with an

RS-232C serial port

This cloning program is designed to perform data

setting and cloning for the dual band transceiver

IC-207H.

l 

MS-DOS, PC-DOS or IBM DOS ver. 5.02 or higher

. OPC-646 CLONING CABLE

CONNECTIONS

I

cloning operations are performed from

computer’s keyboard including power ON 

only connect to a DC power supply is needed

 the transceiver.

 female plug

IC-207H

 level converter circuit)

Personal

computer

-646 Cloning cable

be purchased separately)

INSTALLATION AND PROGRAM START UP

n 

Installation and initial setup’

Connect the transceiver and 

PC as above 

then con-

nect a 

DC power supply to the the transceiver.

To install the CS-207 cloning software to

 directory of drive C while the program

disk is in drive A, type as follows at the DOS prompt:

A : \ I N S T A L L  

A: 

 [Enter]

Program drive

Target drive/directory

A target directory is created if it does 

 already

exist; CS-207 cannot be installed to the root directory.

After the installation is finished, the CS-207 initial

setup screen appears and the transceiver model is

checked. Proceed as follows:

 Select the connected RS-232C 

port with the [ 

 and [Enter] keys.

 Input your call sign then push [Enter].

 After the initial setup, CS-207 is automatically

launched. Set or modify the data as desired.

l 

See the back page for operation.

 the File sub menu to save the data or to exit

the program.

To start the program after installation, operate as

n 

Starting the program

follows at the DOS prompt:

 Change to the installed directory.

l 

 in case of the example at left.

 Type as follows to start:

 [Enter] 

(at the installed directory)

n 

Operating from a floppy disk

This program can be operated from a floppy disk.

 Insert the backup disk into the floppy disk drive.

 Select the floppy disk drive as the current drive.

 Select the 

 directory.

 Type 

 then push [Enter] to start.

NEVER 

remove 

the 

program 

disk from the floppy disk

drive while the program is running.

NEVER set the floppy disk as write-protected.

Cloning will take 20 sec. or more when operating from a

Portions of this software are copyrighted by Microsoft Corporation.

MS-DOS is a Microsoft trademark.

  - -   - - -

, . - . . - - -