Icom IC-2720H Operating Manual - page 4
Icom IC
–2720H Mini–Operating Guide by W5JCK, September 2007
Page 4 of 6
Operating in Memory Mode
● Press L/R
[
M/CALL●MW
]
one or more times to activate Memory mode.
● To change the Memory channel, rotate
[
DIAL
]
.
● To start a scan, press and hold
[
V/MHz●SCAN
]
for 1 second.
● To stop a scan, press
[
V/MHz●SCAN
]
.
Alternatively:
See “Using the HM-133 Microphone” section for instructions
on using the microphone
▲/▼ and/or keypad buttons to perform these
operations.
Memory Bank Selection
The IC-2720H has 10 Memory Banks (A to J), each of which can contain up
to 200 Memory channels. To select a Memory channel within a Bank:
1. Press L/R
[
M/CALL●MW
]
one or more times to activate Memory mode.
2. Press and hold
[
MAIN●BAND
]
for 1 sec. to activate the Memory Bank
selection. (The Bank initial blinks on the LCD display.)
3. Rotate
[
DIAL
]
to display the desired Memory Bank.
4. Press
[
MAIN●BAND
]
to select the Memory Bank. (The Bank initial stops
blinking.)
5. Rotate the Dial to select a Memory channel within the bank.
To return to regular Memory mode, press and hold
[
MAIN●BAND
]
for 1 sec.
then momentarily press
[
MAIN●BAND
]
again.
Using the Monitor Function
This function is used to listen to weak signals
without disturbing the squelch setting.
● To activate, press and hold L/R
[
DUP●MONI
]
for 1
sec. to open the squelch. (The
“Busy” icon blinks
on the LCD display`.)
● To cancel, press and hold
[
DUP●MONI
]
for 1 sec.
Alternatively: Press the HM-133 microphone
button
[
BANK●MONI●1
]
to activate or cancel the
Monitor function.
Selecting the Call Channel
Call channel is a pre-programmed Memory channel
accessed by pressing the Call channel button.
1. Press L/R
[
M/CALL●MW
]
one or more times to
activate Call Channel mode.
2. Rotate
[
DIAL
]
to select the desired call channel.
(In Memory mode, the “C1” or “C2” icon
appears
. In VFO mode, the “c” icon appears.)
3. To cancel Call Channel mode, press
[
M/CALL●MW
]
one or more times.
Alternatively: Press and hold the HM-133
microphone button
[
MR●CALL
]
for 1 sec. to
activate the Call Channel mode, then press
▲ or
▼ to select the desired call channel in the main
Band.To cancel, press
[
MR●CALL
]
to return to
Memory mode.