Icom IC-450 Instruction Manual - Transmitting A Call
24
4
BIIS OPERATION
4
23
4
BIIS OPERATION
■
Transmitting a call
Total of a 3 ways for code selection are available—selecting the call
code from memory, entering the call code from the keypad and call-
ing back from the queue channel record.
D
D
Using call memory
q
While in the standby condition, push [P1] (Digital) to enter the
call code memory channel selection mode.
w
Push [
]/[
] to select the desired call code.
e
Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE:
When no answer back is received, the transceiver re-
peats the call 3 times (default) automatically, and
“
”
is
displayed during each call. However, an error beep sounds
and
“
”
is displayed when no answer back is received
after the calls.
r
Push [PTT] to transmit; release to receive.
t
Push [P3] (Moni(Audi)) to send the “Clear down” signal.
Call code text is displayed.
D
D
Calling back from the queue channel
q
While in the standby condition, push [P1] (Digital) for 1 sec. to
enter queue memory channel selection mode.
w
Push [
]/[
] to select the desired record.
e
Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE:
When no answer back is received, the transceiver re-
peats the call 3 times (default) automatically, and
“
”
is
displayed during each call. However, an error beep sounds
and
“
”
is displayed when no answer back is received
after the calls.
r
Push [PTT] to transmit; release to receive.
t
Push [P3] (Moni(Audi)) to send the “Clear down” signal.
!IC-F50_F60 BIIS.qxd 03.9.12 8:49 AM Page 23 (1,1)