Icom IC-A210 Instruction Manual - page 31
27
5
MENU MODE
■
MENU mode items (Continued)
D External Input Level “AUX LEVEL”
Set the external input level.
• OFF (0) : The external input does not operate.
• 001–080 : Sets the external input level from 1 to 80.
• AF GAIN : Interlocked with [VOL].
D Beep Tone Level “BEEP”
Confirmation beep tones normally sound when storing mem-
ory, operating time-out-timer function, etc. These can be set
a desired beep level as you prefer.
• OFF (0) : The beep tone turns OFF.
• 001–100 : Setting the beep tone level from 1 to 100.
D Intercom Usable Setting “INCOM MODE”
Set the intercom using or not.
• ON
: The intercom is usable.
• OFF
: The intercom is unusable.
D Time-Out-Timer “TIME OUT”
To prevent accidental prolonged transmission, the trans-
ceiver has a time-out-timer function. This timer starts when a
transmission begins, and will cut off the transmission when
the time set in the timer elapses.
• 020–240
: Setting time-out-timer starting period from 20 sec.
to 240 sec. in 10 sec. intervals.
D Interlock “INTERLOCK”
When 2 transceivers are connected together, the interlock
function can prevent them from transmitting at the same
time.
• TX INHIBIT : Transmission is prevented.
• RX MUTE
: Audio output is prevented.
• BOTH
: Transmission and audio output are both prevented.
D Memory Clear “MEM CLEAR”
Set values in the CPU are cleared.
Push and hold
[MEM] for 2 sec., the CPU is reset as follows.
• MENU
: MENU mode items are reset.
• MEMORY
: Stored memories are reset.
• ALL
: All CPU data is reset.
0
5
NOTE:
When using an external speaker, the beep tone
level when the squelch is closed is fixed and cannot be
changed in the MENU mode.
NOTE:
The interlock does not appear when the “TX/RX
INTERLOCK SW” is set to “DISABLE”, by the CS-A210.