Icom IC-F1020 Instruction Manual - page 3
ii
TABLE OF CONTENTS
IMPORTANT ........................................................................ i
EXPLICIT DEFINITIONS ..................................................... i
CAUTIONS ........................................................................... i
TABLE OF CONTENTS ...................................................... ii
1
PANEL DESCRIPTION ............................................. 1–5
■
Front panel ............................................................................ 1
■
Programmable function keys ................................................ 2
■
Function display .................................................................... 5
2
OPERATION ............................................................. 6–8
■
Turning power ON ................................................................. 6
■
Channel selection ................................................................. 6
■
Receiving and transmitting ................................................... 7
D
Transmitting notes ........................................................... 7
D
DTMF transmission ......................................................... 8
3
CONNECTION AND INSTALLATION .................... 9–12
■
Rear panel and connection ................................................... 9
■
Unpacking ........................................................................... 10
■
Mounting ............................................................................. 11
■
Separation .......................................................................... 11
■
Optional UT-105 installation ................................................ 12
4
OPTIONAL SmarTrunk II™ OPERATION ........... 13–15
■
SmarTrunk II™ and conventional modes ............................ 13
■
SmarTrunk II™ operation .................................................... 13
5
OPTIONS .................................................................... 16
DO NOT
use or place the transceiver in areas with tem-
peratures below –30°C (–22°F) or above +60°C (+140°F) or,
in areas subject to direct sunlight, such as the dashboard.
AVOID
operate the transceiver without running the vehicle’s
engine. The vehicle’s battery will quickly run out if the trans-
ceiver is in transmission while the vehicle’s engine OFF.
AVOID
placing the transceiver in excessively dusty envi-
ronments.
AVOID
placing the transceiver against walls. This will ob-
struct heat dissipation.
AVOID
the use of chemical agents such as benzine or al-
cohol when cleaning, as they damage the transceiver sur-
faces.
BE CAREFUL!
The transceiver will become hot when
operating continuously for long periods.
For U.S.A. only
CAUTION:
Changes or modifications to this transceiver,
not expressly approved by Icom Inc., could void your authority
to operate this transceiver under FCC regulations.