Icom IC-F111 Instruction Manual - page 8
5
1
PANEL DESCRIPTION
• OUTPUT POWER SELECTION KEYS
Select the transmit output power temporarily, or
permanently, depending on the pre-setting.
• Contact your dealer for the output power level for each
selection.
• TALK AROUND KEY
TA
Turns the talk around function ON and OFF.
• The talk around function equalizes the transmit fre-
quency to the receive frequency for mobile-to-mobile
communication.
• WIDE/NARROW KEY
Push this key to toggle the bandwidth between
wide or narrow.
• DTMF AUTODIAL KEY
DTMF
Push this key to display the text of the DTMF chan-
nel number and set the desired channel number
via the
[
]/[
] key. Then, push this key again to
transmit a specified DTMF code.
• CALL KEY
Transmit a 2-tone, 5-tone code.
• Call transmission is necessary before you call another
station depending on your signaling system.
• The
[CAL A] and/or [CAL B] keys may be available
when your system employs selective ‘Individual/Group’
calls. Contact your dealer about which call is assigned
to each key.
• EMERGENCY KEY
EMER
Push and hold the key to transmit an emergency call.
• If you want to cancel the emergency call, push and hold
(or push) the key again before transmitting the call.
• Depending on the pre-setting, the emergency call is
transmitted one time only, or repeatedly, until receiving
a control code.
• HOOK SCAN
When the Hook Scan function is turned ON, push
this key to stop scanning temporarily. Push this key
again to re-start scanning.
• TX CODE KEY
TX CH
Select a transmit 5-tone code (station code) chan-
nel.