Icom IC-F3 Instruction Manual - page 8
3
DEALER-PROGRAMMABLE FUNCTIONS
6
D
D DTMF RE-DIAL FUNCTION
This function allows you to transmit the last-used DTMF code
at the push of a key.
To activate the function:
Push the [DTMF RE-DIAL] switch momentarily.
• The previously transmitted DTMF code is automatically transmitted.
• If no code has been transmitted since turning the power ON, this
function does not activate.
D
D HIGH/LOW POWER OUTPUT
This function selects high or low power for a channel.
To toggle between high and low power:
Push the [HIGH/LOW] switch.
• “LOW” appears when low output power is selected.
D
D EMERGENCY FUNCTION
The emergency function allows you to send your ID quickly
and easily to your Base Station, etc. in case of emergency.
To activate the emergency function:
Push and hold the [EMERGENCY] switch for 1 sec.
• The transceiver selects a pre-programmed channel, then sends an
emergency signal to your Base Station.
• The pre-programmed channel remains selected until a control signal
is received from the Base Station or power is turned OFF.
• The emergency call is repeatedly transmitted at pre-programmed in-
tervals.
D
D DISPLAY LIGHTING
The function display has 3 backlight conditions.
OFF: No backlight is available.
AUTO: When any key is pushed, the backlight turns ON for 5
sec. automatically.
CONTINUOUS: Backlight turns ON continuously after power
ON.
D
D SmarTrunk II
TM
functions
This transceiver provides SmarTrunk II™ functions.
(Optional UT-105
SmarTrunk II
TM
Logic Board
is required.)
The optional UT-105 allows communication over conventional
channels or SmarTrunk II™ channels. Select a channel bank
for SmarTrunk II™ before trunking operation.
To toggle SmarTrunk II
TM
channels and conventional chan-
nels.
Push the [Bank Up] switch one or more times.
• Scanning starts when a channel bank for SmarTrunk II™ is se-
lected.
• Contact your dealer for channel bank details.
(See p.9 for more detailed operation.)
IC-F3/S,F4/S SMATRA 7/29 01.12.5 6:02 PM ページ6