Icom IC-F3032S Instruction Manual - page 16
11
3
BASIC OPERATION
TX code channel selection
D
If the transceiver has [TX Code CH Select] assigned to it,
the indication can be toggled between the operating channel
number (or name) and TX code channel number (or name).
When the TX code channel number (or name) is displayed,
[CH Up] or [CH Down] selects the TX code channel.
USING [TX CODE CH SELECT] KEY:
Push [TX Code CH Select] to enter the TX code channel
q
selection mode.
• Select the desired channel with [CH Up] or [CH Down] if neces-
sary.
Push and hold [TX Code CH Select] for 1 sec. to enter the
w
TX code edit mode.
e
Push [TX Code CH Select] several times to select the de-
sired digit to be edited.
• The digit to be edited blinks.
r
Push [CH Up], [CH Down] or 10-keypad to set the desired
digit.
t
Push [TX Code CH Select] to set the digit. The digit to the
right will blink automatically.
• When the 10-keypad is used for setting, the digit to be edited moves
to the right automatically without pushing [TX Code CH Select].
y
Repeat r and t to input all allowable digits.
u
After setting the last digit, push [TX Code CH Select] to set
the code and return to the stand-by mode.
USING [TX CODE CH UP]/[TX CODE CH DOWN] KEY:
If the transceiver has [TX Code CH Up] or [TX Code CH
Down] assignment, the programmed TX code channel can
be selected directly when pushed.
DTMF transmission
D
If the transceiver has [DTMF Autodial] assigned to it, the
automatic DTMF transmission function is available. Up to 8
DTMF channels are available.
TO SELECT A TX CODE:
Push [DTMF Autodial]— a DTMF channel appears.
q
w
Push [CH Up] or [CH Down] to select the desired DTMF
channel.
Push [DTMF Autodial] to transmit the DTMF code in the
e
selected DTMF channel.